Brush Cutter Valves

Brush Cutter Fuel Valve This is an authentic replacement part manufactured for use with Shindaiwa outdoor power equipment. The special fuel valve is used to allow air into the tank to prevent a vacuum inside the tank, and the valve prevents fuel from spilling out of the tank. This fuel valve is available as an individual replacement part, please see model diagram for associative parts.

Brush Cutter Check Valve This is an authentic Shindaiwa replacement part manufactured for use with outdoor power equipment. This special check valve is used with the fuel pick-up line to allow fuel to flow out of the tank, but not back into the tank from the same line. This check valve is sold individually.

Brush Cutter Decompression Valve This is an authentic replacement part that is sourced from the original manufacturer to be used with chainsaws. The special valve is threaded and screws into the cylinder. The valve is used to allow air to escape the combustion chamber to make it easier to turn the engine over when pulling the recoil starter rope. The valve is opened prior to starting the engine and combustion within the cylinder causes the valve to close once the motor is started. A hex socket wrench is required to install this item and the valve is sold individually.

Brush Cutter Valve

Brush Cutter Throttle Valve Assembly

Brush Cutter Valve

Brush Cutter Throttle Valve

Brush Cutter Valve

Brush Cutter Valve/inlet A replacement inlet valve component used in small two-stroke and handheld engine applications to regulate intake flow; manufactured to OEM tolerances for correct fit and consistent engine performance.

Brush Cutter Valve