Bostitch Parts

This head valve body regulates airflow within pneumatic nailers, helping generate the pressure needed to drive fasteners effectively. Built from durable materials, it supports consistent tool performance. Replacing a worn or faulty valve can resolve issues such as air leaks, reduced driving power, or failure to fire, restoring reliable operation.

Length: 8' Gauge: 18 Wires: 2 Type: Bare Wire This cord is a genuine DeWalt replacement part. This cord is compatible with the list of models below. This part is made for double insulated tools It is a two wire cord with two prongs and does not need a ground wire. The cord is sold individually. Installation of this part requires the new cord wires to go correctly into wire terminals also routing the cord and wires in the right path can help avoid pinching when the tool case (Plate) is put back into place.

This is an authentic Bostitch replacement part used on specific Nailers. This is a Rubber Ring and it is sold individually. O-rings are designed to withstand thousands of pounds of pressure by creating a seal between two or more parts.

Genuine Manufacturer Sourced replacement part used on Bostitch Stapler. This part is made out of Metal and it is Sold Individually. This Driver along with a Flat Spring are both attached with the same Screw to the Frame. Please note all parts are Sold Separately.

it is a genuine item that is supplied directly from the original equipment manufacturer for use with Craftsman air compressors. This high-quality belt provides an identical replacement for a missing or damaged component that was originally installed on a new unit, please make sure to refer to the appropriate diagrams of your model for the correct location and application of this item. Keep in mind this high-quality belt is made of durable rubber and is sold individually,

This air compressor regulator repair kit restores proper pressure control and airflow by replacing worn internal components such as seals and the piston. Designed to address leaks or inconsistent pressure, it helps return the regulator to reliable working condition. Replacing damaged parts with this kit can improve performance and ensure consistent operation.

This is a Genuine OEM sourced replacement part designed for use with Staplers/Nailers. With this Exhaust Cover you can divert the air in any direction you want. It is made out of Plastic and it is Sold Individually. Please note Flange Nut used to secure the Cover is Sold Separately. To replace this item you would need a Hex Key/Allen Wrench.

Restore reliable firing power with this piston head valve, a key component that controls airflow within the nailer's cylinder assembly. By directing air pressure to drive and return the piston during each firing cycle, it helps maintain consistent performance and efficient operation. A worn, cracked, or damaged valve can cause air leaks, reduced driving power, or improper cycling, making replacement an important step in restoring tool performance. Because internal component locations can vary between models, refer to your tool's parts diagram or service manual to confirm the correct placement before installation.

Genuine Bostitch replacement part, this item is sold individually. The Piston/Driver Assembly is the part of the nail gun that drives the nail into the material that is being used. To help extend the life of a pneumatic tool use the specified oil in it daily 4-5 Drops will do every time you use it. The Piston/Driver Assemblies do have a tendency to bend or break if not used correctly or if you are driving nails into extra hard material.

This is a Genuine Manufacturer Sourced replacement part designed for Nailers/Staplers. This O-Ring provides an Air-Tight Seal for the Valve Piston. Over time this O-Ring will shrink, become brittle and crack allowing for air leaks. At that time it should be replaced. It is made out of Rubber and it is Sold Individually. Replacing this item you would need Hex Key/Allen Wrench and Pliers to replace this item.