Bissell Parts

Bissell Roller Assembly This is a Genuine OEM replacement part designed for use with Bissell Vacuums. This part is made out of Plastic. It consists of a Bracket/Roller and Plastic Wheels. Please note, Brushroll Assembly is Sold Separately. When replacing this part you will need to remove an Access Plate using a Screwdriver. Snap the roller into place, attach Brushroll Assembly and connect the belt to the spindle that turns the belt.

Bissell Vacuum Belts Genuine Bissell replacement belts used on Vacuums. This is the Pack of Two (2) belts. Belts tend to stretch over time, so it is recommended to change them at least every 6 months for optimum performance.

Bissell Lever Release The release lever attaches to the top cover and is used to put the vacuum cleaner in different positions. This part is available individually and is a genuine replacement part sourced from the original manufacturer for use with Bissell bagless upright vacuums. It is made out of plastic and will require replacing if it breaks. While replacing this part a screwdriver may be needed.

Bissell Solenoid Valve This is an original Bissell part. This Solenoid Valve is used in many models of Bissell Carpet Cleaners. When powered, this valve allows the flow of water at the press of a button or the pull of a trigger. This part should be replaced when water will not flow or when it won't stop flowing. When replacing the Valve, double check the condition of the Tubing (part number B-203-6819) making sure that it is free of cracks and splits. Tools Used: • Philips Screw Driver • Needle Nose Pliers

Bissell Silicone Tube 7.9 Mm Od, 4.9 M This is an original Bissell replacement part. The silicone tube is designed by the manufacturer for use in carpet cleaners. This part is use to carry water or cleaning solution through the machine. Because there are multiple similar tubes in the machine, it is advisable to label the tubes with the places they connect, or to take a picture, before removing these parts for replacement. The silicone tube is sold individually.

Bissell Foot Motor Assembly

Bissell Pivot Arm Retainer Assembly This authentic OEM retainer assembly secures the left and right pivot arms of the brush roll assembly on your steam vacuum. The pivot arms allow the brushes to move and adjust to various surfaces for effective cleaning, and the retainer assembly ensures they stay in place during operation. The assembly comes with the necessary hardware for replacement and is typically located on the sides of the front base, beneath the plastic base window. If you notice that the pivot arms are loose or worn out, it is time to replace the assembly. To remove it, refer to your user manual to locate and access it at the base of your vacuum. Unthread the mounting screws and remove the old assembly from its housing, then proceed with installing the new assembly. Please remember that this includes both the left and right pivot arm retainers along with the necessary fasteners for installation.

Bissell Autoload Gasket The autoload gasket is made out of rubber and attaches to the tank. This part is available as an individual replacement. This authentic item is supplied directly from the original equipment manufacturer for use with carpet cleaners by Bissell. No tools should be needed during the replacement of this part. It may become broken and will need to be replaced.

Bissell Foam Filter Genuine Bissell replacement part, this item is sold individually. This Filter is a Pre-Filter, which means it will pick larger debris that the Vacuums pick up before it enters the main Filter. The main Filter will pick up the smaller particles and debris. The B-203-1192 Foam Filter can be washed with water and then left to dry before using it again. Do not use soap when washing this Filter, use water only.

Bissell Flow Indicator Assembly

★★★★★

★★★★★

1 Review

This is an authentic Bissell replacement part. The flow indicator assembly is designed by the manufacturer for use in carpet cleaners. This part is made primarily of high-quality plastic, and is placed in the housing to monitor the flow of liquid through the machine. This item is supplied as an individual replacement part.