Angle Grinder Hardware

This is a Genuine Manufacturer Sourced replacement part used on Dewalt Angle Grinders. The purpose of this Clamp Washer is to provide support for the Grinding Wheel to the Spindle Shaft. This Clamp Washer is made out of Metal and it is Sold Individually. You would need Hex Wrench to replace this part.

Genuine Milwaukee replacement part, this item is sold individually. This Flange nut is threaded on the spindle of the Milwaukee Grinders shown below. You first place the inner flange on the spindle , part number 43-34-0036. Then you place the grinding wheel of choice on the spindle. The Flange Nut is then threaded on the spindle preferably by using a spanner wrench which fits into the holes of the Flange Nut.

Secure wheel mounting is essential for safe angle-grinder operation. A stripped, cracked, or bent retaining nut can allow the accessory to wobble or loosen at high speed. Check that the wheel type, bore, inner flange, and spindle threads are correct before ordering a replacement. Match the nut to the full tool model and parts diagram. Disconnect power, wear eye protection and gloves, and use the approved wrench. Never install a damaged wheel or force a nut with the wrong thread onto the spindle.

The spindle lock pin fits next to the o-ring and the spring. This item is priced individually. It is an authentic OEM sourced item which is specially produced for use with DeWALT angle grinders. A screwdriver may be necessary during the installation of this part. The pin is made out of metal and will need to be replaced if it bends or breaks.

This genuine Makita replacement part is designed for use with a variety of power tools. This screw is a standard hardware which has multiple applications based on your tool. It is made out of metal and it is sold individually. Would require a screwdriver to install or remove this screw.

This spindle lock pin is an OEM direct from the Milwaukee manufacturer. The metal pin is made for use with (SER B96A) Cordless 18 Volt 4-1/2" Cut-Off/Grinders. Fitted in the gearcase kit, this component is designed to lock the spindle. A hex key and pliers are helpful to the repair process. The spindle lock pin is sold individually.

This screw is commonly used on a variety of power tools. It is a genuine OEM sourced replacement part. Please make sure to check appropriate diagrams for correct location and use of this screw. Includes one pan head screw per order. You will need a screwdriver to install or remove it.

it is an authentic high quality Makita replacement part that is specially manufactured for use with sanders and grinders. This is the insulation washer for the armature, please make sure to check appropriate diagrams for correct location and use of this item. One durable plastic washer is included per order.

Genuine Makita replacement part, this item is sold individually. The purpose of this Clamp Nut is to secure the Grinding wheel to the spindle of the Grinders shown below. To tighten the nut to the spindle, you will need to depress the spindle lock assembly on top of the gear case. Then use the part number 782422-3 Spanner Wrench to loosen and then tighten the nut back on.