Andis Parts

This is a genuine high quality switch assembly that is sourced directly from original equipment manufacturer for use with Andis clippers. It is the part of the tool that allows user to turn the unit on and off. Over time mechanical switches will wear out and may begin to fail eventually requiring replacement. Replacing it is a simple task that should only require a screwdriver. One durable plastic switch with two lead wires attached is included per order.

This is an authentic replacement part manufactured for Andis clippers. This molded rubber switch button is the cover seen from the side of the clipper, when pressed the button engages the circuit board. Overtime the switch button can wear exposing the circuit board, it is recommended to replace worn switch buttons. The switch button is sold individually, and the circuit board is available separately.

This part comes directly from Andis. This Tension Spring is used in multiple models of Andis hair trimmers. The Spring is made of metal and includes the nylon tip. The Spring holds tension on the cutter of the blade. If the blade doesn't move, then this part should be replaced. This part is commonly purchased with the Tension Screw (part number 32527) and the Retaining Screws (29752). Tools Used: • Flat Head Screw Drivers • Philips Head Screw Driver

This is a genuine OEM sourced replacement part designed for use with Andis clippers. This assembly includes one (1) carbon brush with a lead wire attached. Please note brush spring and retaining clip are both sold separately. Due to normal use and friction brushes will gradually wear down and will require replacement. It is advised to replace both brushes at the same type. You would need a screwdriver to complete this job. • Make sure the unit is unplugged • First remove cover • Take our old brushes and replace them with the new ones • Secure the cover and test the tool

This part is manufactured by Andis. This Hinge Assembly is used on many models of Andis hair clippers. The Hinge Assembly includes the Blade Lock (part number 64537). This part holds the cutting blades into place while cutting hair. If the blade feels loose or won't stay in place, then the Hinge Assembly needs to be replaced. To replace this part two Blade Hinge Screws (27864) will need to be removed. A Philips screwdriver is all that is needed for the replacement of this part.

This genuine manufacturer-sourced part is specially made for use with Andis clippers. The armature is the main portion of an electric motor which rotates the shaft. You'll need to replace the armature if you notice smoke or sparks coming from the vents on the back of your equipment. If this happens, you've probably overloaded your armature and some point, which caused the insulation to break down. It provides an identical replacement for a faulty or a missing component that was installed on a new unit. Check the owners manual and the diagrams of your specific model for the correct installation of this armature. Note, this high-quality part is sold individually.