Amana Ice Maker Hardware

Your Price

$7.47

Amana Ice Maker Refrigerator Screw

★★★★★

2 Reviews

PartSelect Number PS11747542

Manufacturer Part Number WP98165

This screw is a little under an inch long and is made of metal. It is used with a refrigerator's ice maker assembly. Sold individually.

Installation Instructions

Lynn H from MILL CREEK, WA

Hinge pin for drawer lid broke

1. Remove all drawers {3}, shelves {glass 1}, shelf support {1}. 2. Remove two {2} screws from End Cap. 3. Carefully remove End Cap and drawer temperature control part on the back wall keeping them aligned as installed. The part on the back wall swings out so that the tab on the left end of the piece may be withdrawn from the securing slot (hole). The two parts should be carefully removed while keeping the two parts at a right angle the way they are installed. The reason for this caution follows. 4. On the back side of both parts are plastic pieces that, I believe, can be easily broken if you are not aware. The pieces are connected together at the right angle. They are the control arms for the temperature control -- on right side End Cap only -- the left side doesn't have them or the rear part on the back wall. 5. The pieces must be disconnected and removed. You must examine and ponder how they are held in place and hooked together in order to disconnect and remove them without damaging them. The same advice is applicable to reinstalling the pieces in the new part -- End Cap. 6. After reassembled and keeping the two parts at a right angle, insert the tab on the left end of the back wall part into the slot (hole) and swing the two parts back into position. 7. Replace the screws. 8. Done, reinstall the shelf, shelf support, and the drawers. NOTE: I ordered the two screws but they were not needed. Read more...

Your Price

$18.22

Amana Ice Maker Scoop

★★★★★

4 Reviews

PartSelect Number PS12745542

Manufacturer Part Number W11420408

This ice maker scoop is an OEM refrigerator part designed to retrieve ice from the ice maker bin. It is made of plastic and measures approximately 10 3/4 inches in length and 4 inches in width. The scoop is designed to fit inside the ice bin for easy access. You will need to replace the scoop if it is cracked, broken, or lost. Discard the old scoop and insert the new one into its designated compartment.

Your Price

$9.62

Amana Ice Maker Refrigerator Screw

★★★★★

1 Review

PartSelect Number PS11745622

Manufacturer Part Number WP8281196

Sold individually.

Installation Instructions

Carol from Monroe, NY

Refrig making a lot of noise

The motor kit had only two wires coming out of it. The existing one in the refrig had 6. I spliced the 2 red to one black on the new part and 2 white to the other black wire on the new part. The two green I attached to a screw. I left the 6 wire harness in place just cut off the plug piece that went into the old motor, and spliced all my wires.
Worked great! Read more...

Your Price

$21.45

Amana Ice Maker Screw

★★★★★

6 Reviews

PartSelect Number PS12349731

Manufacturer Part Number W11233072

This is a multi-use and multi-appliance screw. It can be used on a microwave, refrigerator, range/oven, air conditioner, dehumidifier, washer, or dryer. The measurements of this screw are 8 x 1/2 inch. It has 6 threads. Refer to the manual provided by the manufacturer for further information on repair and accurate guidance. Remember to wear work gloves as a safety precaution.

Installation Instructions

Ronald from Northfield Center, OH

changing stove and dishwasher to match new frig.

I actually replaced parts on my black double stove to make it into stainless. We purchased a new frig and needed to replace parts on our stove and dishwasher so they would match. They look beautiful, all the parts shipped when they were suppose too. Ordering from this company was top notch. Would order again if needed. Read more...

Your Price

$7.47

Amana Ice Maker Screw

PartSelect Number PS1845599

Manufacturer Part Number 67006425

This screw is sold individually

Your Price

$9.62

Amana Ice Maker Refrigerator Screw

PartSelect Number PS11742751

Manufacturer Part Number WP489464

Sold individually.

Your Price

$11.77

Amana Ice Maker Transformer Screw

PartSelect Number PS11742722

Manufacturer Part Number WP488787

This screw is sold individually. It is a genuine OEM replacement part, and it is designed for use with refrigerators. Most often it is used with the ice bucket ice deflector, retainer clip, and front cover. Due to varied uses we recommend referring to model-specific diagrams for exact placement. This screw measures 8-18 by 1/2 inch.

Your Price

$11.77

Amana Ice Maker Refrigerator Speed Clamp Clip

PartSelect Number PS11747913

Manufacturer Part Number WPM0114003

This is a speed lamp clip, and may also be known as the water line spring clamp. It is used in conjunction with your refrigerator. If you have a leak at your fill tub, this part may be the reason. The function of this clip is to keep the fill tube and the water line connected. This will allow water to flow freely without leakage into your water/ice dispensers. This part is quite small, with less than a half-inch in outer diameter. The clip is an off-black, almost olive color, and is rounded.

Fixes these symptoms

Leaking
See more...

Installation Instructions

Richard from Yarmouth, ME

Leak at fill tube

Removed two screws that held cover plate. remove cover plate. Remove water hose, and clamp, by compressing clamp with pliers. Remove fill tube by pulling HARD, from back.

Replace fill tube, check to be sure that it entered ice maker properly. Replace hose and clamp.
Replace cover and screws. Read more...