Quick Question!

Have you ever purchased from PartSelect.com before?

Models > ZVB30BB3BB

ZVB30BB3BB General Electric Range Hood - Overview

Get Parts and Repair Help for ZVB30BB3BB

If you know the range hood repair part you need, you can browse the list of all parts on the ZVB30BB3BB, or you can search by name or part description. You can also find your part by where it is located on the ZVB30BB3BB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range hood. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the ZVB30BB3BB

[Viewing 1 of 1]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$17.52

Single Roller

This is a single roller and it is a part for multiple appliances in your household. You may also know this as a bearing roller or a wheel assembly. It is roughly one inch by one in...

Order within the next 1 hr and 27 mins and your part ships today!
$183.65

Hood Gear Motor

Order within the next 1 hr and 27 mins and your part ships today!
$110.52

CONTROL BOARD KIT

Order within the next 1 hr and 27 mins and your part ships today!
$133.17

SWITCH VARIABLE SPEED

Order within the next 1 hr and 27 mins and your part ships today!
$130.37

RAISE/LOWER REMOTE KIT

$86.32

CORD POWER

$49.01

TRIM SWITCH EMBOSSED

Order within the next 1 hr and 27 mins and your part ships today!
$99.30

"FILTER 30"" PKG QTY 1 "

$205.35

REMOTE TRIM KIT WHT

Order within the next 1 hr and 27 mins and your part ships today!
$200.13

"TRIM 30"" MONOGRAM BLAC

Common Symptoms of the ZVB30BB3BB

[Viewing 1 of 1]
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Controller board fried

  • Customer: Anthony from Stevensville, MD
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Wrench set
  • 4 of 6 people found this instruction helpful
Disconnected power and removed electrical cover
Disconnected wires from old controller one a time and connected to new controller as to not mismatch wire connections. Left new controller hanging off wires.
Raised vent and held using wood blocks to expose gap to use 1/4 inch wrench to undo screws from the inside (poor design for replacing the contr... read more