The function of the oven sensor is to detect the temperature within the oven cavity. If you notice that the oven is too hot or too cold, or it is not heating evenly, you may need to replace the oven s...
$36.68
In Stock
Order within the next 8 hrs and your part ships today!
This part is a replacement screw for your oven. It is made of black metal and is sold individually. This screw is approximately 1/4 inch in diameter and about 1/2 inch in length. It is designed to con...
$12.20
In Stock
Order within the next 8 hrs and your part ships today!
Order within the next 8 hrs and your part ships today!
Questions And Answers for ZET1PM1SS
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Patrick
December 13, 2021
F9 code comes up after oven has been for 15-20 mins temp over 375
For model number ZET1PM1SS
Hi Patrick,
Thank you for your question. The F9 error code is letting you know that the electronic control board has sensed an issue with the door lock. This may result from an issue with the electronic control board, a jammed door lock, an issue with the wires connected to the lock, or a malfunctioning lock switch. You will need to inspect these parts to see which one is causing the issue. To verify of the lock is working correctly, you will need to test it for continuity with a multimeter. Set your multimeter to Rx1 and ensure the switch is turned to the “clean" position. Using the probes, touch the terminals of the switch, this should produce a reading of zero or nearly zero. If your test results show that there is no continuity, you will need a replacement door lock switch. To verify if the issue is with the electronic control board, you will need to inspect it for signs of damage, wear, or scorching or burn marks. If it shows any of these signs, it will need to be replaced. We hope this helps! If you have any questions, please let us know.
I had to remove the oven from the wall because the sensor plug connction is behind the unit. Two screws hold the sensor inside the oven and then I disconnected the lead and pulled the sensor out from the front. I installed the new sensor, tightened the two screws holding it in and connected the lead. Then reinstalled the oven into the wal
... Read morel. Overall, a very easy repair once you get the oven out.
Removed the oven door for easy acces to oven. Unscrewed (philips screwdriver) the screw holding temp sensor in place. Gently pulled the wiring until quick connector was located. Pushed down on locking level on quick connect while holding other end of wiring (so wiring would not fall back behind oven). Connected the new sensor and scre
... Read morewed back in place. Reinstalled oven door. Tested temperature settings by turning on oven and comparing with a separate oven thermometer.
Followed instructions and removed door. Loosened screws/bolts. Pulled the door apart. Removed the bracket that would hold the glass. Removed the broken glass and inserted the replacement glass. Re-assembled the door and reinstalled the door. Took all of 20 mins.