TDG336REW0 Tappan Dryer Parts & Repair Help | PartSelect
Models > TDG336REW0

TDG336REW0 Tappan Dryer - Overview

Get Parts and Repair Help for TDG336REW0

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
(70)
PartSelect #:PS459829
Manufacturer #:5303281153
This rear drum bearing kit is designed for use with dryers. It supports the rear of the drum in your appliance as it tumbles your clothes during the drying cycle. If your drum will...
$27.29
In Stock
Order within the next 6 hrs and your part ships today!
(35)
PartSelect #:PS1148434
Manufacturer #:134503600
This drum belt, often referred to as a drive belt, is used in the assembly of dryers. It goes around the drum, the idler pulley, and the motor pulley. As the armature on the motor ...
$11.12
In Stock
Order within the next 6 hrs and your part ships today!
(17)
PartSelect #:PS470317
Manufacturer #:5303937139
The upper drum glide is attached to the front panel of your dryer, you can locate it by removing the top portion of your dryer. The drum glide allows the drum to rotate with ease a...
$31.10
In Stock
Order within the next 6 hrs and your part ships today!
(12)
PartSelect #:PS418807
Manufacturer #:131825900
If your dryer does not tumble, will not start, is noisy, or is leaving marks on your clothing, you may need to replace the drum support bearing. The drum is supported at the rear b...
$4.03
In Stock
Order within the next 6 hrs and your part ships today!
(3)
PartSelect #:PS460194
Manufacturer #:5303283286
The front lower drum seal is used in the assembly of dryers. This seal helps keep your appliance running quietly. It allows the drum to smoothly rotate on the front panel. If you n...
$26.24
In Stock
Order within the next 6 hrs and your part ships today!
(11)
PartSelect #:PS418433
Manufacturer #:131658800
The door catch on your dryer is an important part as it keeps your dryer door closed, in order to ensure no air or clothes can escape. This part works by holding the door strike, w...
$32.94
In Stock
Order within the next 6 hrs and your part ships today!
(21)
PartSelect #:PS470049
Manufacturer #:5303931775
This kit contains two coils, one is a two-wire secondary coil and the other is a three-wire booster coil. Both coils in the ignition coil kit should be used together in the clothes...
$26.44
In Stock
Order within the next 6 hrs and your part ships today!
(1)
PartSelect #:PS12579101
Manufacturer #:131724301
$6.51
On Order
(1)
PartSelect #:PS418736
Manufacturer #:131777700
This ball hitch provides support to the drum located at the back wall of the dryer. This allows the drum to spin. The bearing may have gone bad and you might notice that the ball i...
$51.33
In Stock
Order within the next 6 hrs and your part ships today!
(5)
PartSelect #:PS417841
Manufacturer #:131450300
Located at the front of the dryer, this lint filter traps lint and debris from the exhaust air flowing out of the dryer drum. This part measures approximately 12 inches long x 7 in...
$16.72
In Stock
Order within the next 6 hrs and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Squealing noise

  • Customer: Cynthia from Lexington, SC
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Wrench (Adjustable), Wrench set
  • 506 of 522 people found this instruction helpful
We followed the instructions for the drum glide replacement and changed the belt and drum support bearing piece, cleaned it out too. Works like a charm. Thanks for saving us a bundle. read more

Loud Squeaking

Rear Drum Bearing Kit – Part Number: 5303281153
  • Customer: Frank from Boyertown, PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 303 of 312 people found this instruction helpful
1. Unplug dryer from outlet
2. Using Lg. flat screwdriver, pry under the front edge of the top and release two spring tabs
3. Lift up top and tilt back out of your way
4. Unscrew two phillips scews on inside of front panel
5. Lift up and out the front panel. Two spring clips at bottom.
6. Rlease tension on drum belt at the motor. Acc... read more

Motor would hum but not turn on when start knob was turned.

  • Customer: Elvis from Miami, FL
  • Difficulty: Easy
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 210 of 243 people found this instruction helpful
The motor bearings had stiffened up – classic planned obsolescence.

I could tell the motor was bad, because when I tried to spin the drum by hand, it wouldn't turn in any direction. (Normally it can turn fairly easily.)

(Helpful hint: As you remove screws / parts, place them in a plastic baggie, and write on the baggie from whence t... read more