TDE546RED0 Tappan Dryer Parts & Repair Help | PartSelect
Models > TDE546RED0

TDE546RED0 Tappan Dryer - Overview

Get Parts and Repair Help for TDE546RED0

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
(70)
PartSelect #:PS459829
Manufacturer #:5303281153
This rear drum bearing kit is designed for use with dryers. It supports the rear of the drum in your appliance as it tumbles your clothes during the drying cycle. If your drum will...
$27.29
In Stock
(35)
PartSelect #:PS1148434
Manufacturer #:134503600
This drum belt, often referred to as a drive belt, is used in the assembly of dryers. It goes around the drum, the idler pulley, and the motor pulley. As the armature on the motor ...
$11.12
In Stock
(17)
PartSelect #:PS470317
Manufacturer #:5303937139
The upper drum glide is attached to the front panel of your dryer, you can locate it by removing the top portion of your dryer. The drum glide allows the drum to rotate with ease a...
$31.10
In Stock
(12)
PartSelect #:PS418807
Manufacturer #:131825900
If your dryer does not tumble, will not start, is noisy, or is leaving marks on your clothing, you may need to replace the drum support bearing. The drum is supported at the rear b...
$4.03
In Stock
(13)
PartSelect #:PS418120
Manufacturer #:131553900
This dryer heating element produces heat to dry clothes and is located in the rear of a dryer. If the heater element is burned, the dryer does not heat or over heats, or clothes ar...
$77.19
In Stock
(3)
PartSelect #:PS460194
Manufacturer #:5303283286
The front lower drum seal is used in the assembly of dryers. This seal helps keep your appliance running quietly. It allows the drum to smoothly rotate on the front panel. If you n...
$26.24
In Stock
(10)
PartSelect #:PS419402
Manufacturer #:134120900
The dryer thermal limiter, also known as a thermal fuse, blows the fuse to cut off power to the dryer when the dryer begins to overheat. Once the dryer reached 220 degrees Fahrenhe...
$10.82
In Stock
(11)
PartSelect #:PS418433
Manufacturer #:131658800
The door catch on your dryer is an important part as it keeps your dryer door closed, in order to ensure no air or clothes can escape. This part works by holding the door strike, w...
$32.94
In Stock
(1)
PartSelect #:PS12579101
Manufacturer #:131724301
$6.51
On Order
(1)
PartSelect #:PS418736
Manufacturer #:131777700
This ball hitch provides support to the drum located at the back wall of the dryer. This allows the drum to spin. The bearing may have gone bad and you might notice that the ball i...
$51.33
In Stock
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Squealing noise

  • Customer: Cynthia from Lexington, SC
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Wrench (Adjustable), Wrench set
  • 507 of 523 people found this instruction helpful
We followed the instructions for the drum glide replacement and changed the belt and drum support bearing piece, cleaned it out too. Works like a charm. Thanks for saving us a bundle. read more

Loud Squeaking

Rear Drum Bearing Kit – Part Number: 5303281153
  • Customer: Frank from Boyertown, PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 303 of 312 people found this instruction helpful
1. Unplug dryer from outlet
2. Using Lg. flat screwdriver, pry under the front edge of the top and release two spring tabs
3. Lift up top and tilt back out of your way
4. Unscrew two phillips scews on inside of front panel
5. Lift up and out the front panel. Two spring clips at bottom.
6. Rlease tension on drum belt at the motor. Acc... read more

short circuit with a brasier metal support

  • Customer: Juan Carlos from Weston, FL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 222 of 255 people found this instruction helpful
Disconect the dryer from the main power source.

1) Remove the two screws from the rear / upper panel (below the control panel).

2) Snap the front side using a flat head screw driver.

3) On the inside front, remove two screws (one on each side) from the upper side and snap the door assembly off.

4) Remove the rear m... read more