This genuine OEM halogen bulb provides bright, heat-resistant interior lighting for select wall ovens and ranges, making it easy to check cooking progress. Rated at 10 watts and 12 volts with a G4 bi-pin base, it’s a simple plug-in replacement for a dim, flickering, or burnt-out oven light. Designed for specific models, it restores clear visibility inside the oven for everyday cooking.
An oven that suddenly stops heating may have an open high-limit switch. This safety device monitors heat near key electrical parts and interrupts power if the temperature reaches its set limit. Its 220?F rating must match the appliance design. A tripped or failed switch can prevent normal operation, but it should not be replaced without c...Read morehecking why the area became too hot. Inspect the cooling fan, vents, wiring, connectors, and control system first. Turn off the circuit breaker and confirm that no power is present before service. Let all surfaces cool, transfer the wires carefully, and install the switch in its original position.
This oven door hinge assembly supports controlled opening and closing while helping the door remain properly aligned. Replace a worn or damaged hinge when the oven door no longer moves or sits as it should. Verify fit with your appliance before ordering.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
F2 Alarm and oven beeping
3 of 3 peoplefound this instruction helpful.
David from CAMILLUS, NY
Easy
15 - 30 mins
Screw drivers
Replaced relay board
Was this helpful?
Thank you for voting!
Replaced bottom relay control panel
2 of 2 peoplefound this instruction helpful.
David from BUENA VISTA, CO
Really Easy
30 - 60 mins
Screw drivers
First disconnected power to the oven at circuit breaker box. Then, Removed top front control panel, held by four screws exposed when top oven door is opened. Was able to move control up and out of the way without disconnecting. The relay control panel is visible on the right. I was able to reach all connectors with needle nose plie
... Read morers and then remove the panel with needle nose to release clips and use screw driver to gentle pry up. Installed new unit by attaching back connectors and then setting panel down onto clips. Finished with attaching front connectors. Reattach front control panel.
Read less
Was this helpful?
Thank you for voting!
Dacor sent a different bulb # which I CANNOT get back into the oven.
2 of 3 peoplefound this instruction helpful.
Marilyn from INDIAN WELLS, CA
Very Difficult
More than 2 hours
Screw drivers
I have contacted Dacor repeatedly with no response, by both phone and left my return contact and email. I could not be more disappointed in Dacor. All this for a problem which is listed as a home maintenance issue. A light bulb for $41.77 that I cannot install.