LFX31925ST LG Refrigerator Parts & Repair Help | PartSelect
Quick Question!

Have you ever purchased from PartSelect.com before?

Models > LFX31925ST (04)

LFX31925ST (04) LG Refrigerator - Overview

Get Parts and Repair Help for LFX31925ST

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
(12)
PartSelect #:PS3531958
Manufacturer #:ADQ36006101
This genuine LG water filter is used in your refrigerator to help reduce contaminants and chlorine taste that may be in the water supply. The water filter measures 2” in diameter a...
$66.93
In Stock
(3)
PartSelect #:PS8752913
Manufacturer #:MJB63190001
This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighte...
$4.98
In Stock
(8)
PartSelect #:PS3654115
Manufacturer #:ADQ73214404
Refrigerator Air Filters are a key component for neutralizing odors and ensuring a fresh stream of air into your refrigerator. Swapping your old filter out for a fresh one isn’t di...
$26.46
In Stock
(4)
PartSelect #:PS3637058
Manufacturer #:AAP73252202
$53.99
In Stock
(1)
PartSelect #:PS3535435
Manufacturer #:MEG61899901
This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is...
$5.44
In Stock
(11)
PartSelect #:PS3649794
Manufacturer #:MHL42613220
This glass shelf provides storage space in your refrigerator above the crisper. Shelves can crack and chip due to frequent use, and should be replaced immediately if cracks start t...
$37.47
In Stock
(5)
PartSelect #:PS7788173
Manufacturer #:AEQ73110205
NOTE: As per manufacture the secondary (smaller) wire connector has 6 wires in it. If original ice maker has 3 wire connector see part number PS7788172. Please verify connector bef...
$161.55
In Stock
(2)
PartSelect #:PS3522801
Manufacturer #:4004JA3002A
This water tubing clip holds the water fill tube in place in your refrigerator. The water fill tube attaches and supplies water to the ice maker/water dispenser in your fridge-free...
$9.01
In Stock
PartSelect #:PS3524389
Manufacturer #:4932JA3009A
$9.01
In Stock
PartSelect #:PS3648830
Manufacturer #:MEA62590401
$8.37
On Order
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Remove and replace light switch

Switch,Push Button – Part Number: 6600JB1010A
  • Customer: Debbie from Waltham, MA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 25 of 35 people found this instruction helpful
Video makes it look easy. Kenmore refrigerator does not have "groove" along the right hand side of switch that allows for pushing down on release. Used a thin screwdriver to get under to push while holding switch edge with pliers. Kept slipping. Tape sides to avoid scratching inside of refrigerator. read more

Ice / water dispenser control panel cover discolored at bottom due to splashing water

COVER,DISPLAY – Part Number: MCK66585116
  • Customer: James from ST AUGUSTINE, FL
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 9 of 10 people found this instruction helpful
I suggest turning off the water valve and power to the refrig before starting work. If this is not done the water dispenser will probably spray water down the front of the refrig. The whole icemaker assembly must be pulled out from the front. It is a friction fit--just insert fingers in the ice chute and pull out. The entire piece will pull out from the door... read more

Fridge light would not come on.

Switch,Push Button – Part Number: 6600JB1010A
  • Customer: Grace from GALLOWAY, NJ
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 6 of 7 people found this instruction helpful
After watching a few iTunes videos I was able to order the light switch from part select and within a week I had the new switch. I had a little trouble getting the switch out. I used a flat screw driver and taped around the edge to keep from damaging the wall inside. I found the clip on the right side and had to use some force to get it popped out, you may n... read more