Quick Question!

Have you ever purchased from PartSelect.com before?

Models > LFX28978ST (00)

LFX28978ST (00) LG Refrigerator - Overview

Get Parts and Repair Help for LFX28978ST

If you know the refrigerator repair part you need, you can browse the list of all parts on the LFX28978ST, or you can search by name or part description. You can also find your part by where it is located on the LFX28978ST by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$81.56

Door Mullion - White

$53.27

Water Filter

Sold Individually.

$4.35

Handle Screw

This handle screw, also known as a mounting bolt, is a mounting screw to help secure the door handle to your refrigerator door. If your handle is loose, you may just need to tighte...

$59.13

Door Gasket - Gray

This door gasket is used to make an air-tight seal for the cabinet when the door is closed

$5.72

Holder,Door

This is a manufacturer-approved refrigerator door closure for your refrigerator. It is made of white plastic and measures approximately 3 inches by 2 inches. If your old closure is...

$32.77

Basket Assembly,Door

The basket assembly is attached to the inside of the refrigerator door, and typically holds condiments, jars, and bottles. This OEM basket assembly is made of white plastic, and measures approximately 16 inches wide x 5 inches high x 4 inches deep. These parts should fit tightly to the door of your refrigerator, if yours is loose you should replace it immediately, as it could result in its contents spilling into the inside of your refrigerator, or onto the floor.

$46.54

SHELF, GLASS

$4.35

Spring,Lever

This genuine OEM lever spring exerts tension between the ice maker door plunger and the ice maker itself on your refrigerator. If there is little to no tension holding your ice door seal in place, the spring may be faulty. This spring is approximately 1-inch long. Remember to disconnect the power to your refrigerator before beginning this repair.

$114.27

Ice Bin Assembly

This part includes the container, auger and blades.

$102.43

Water Inlet Valve Assembly

This includes the primary and secondary valves along with the wire harness.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

replace leaking water inlet valve assembly

  • Customer: Richard from JACKSONVILLE, FL
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 5 of 6 people found this instruction helpful
1. Shut off water to refrigerator. 2. Removed bottom sheet metal cover (6 screws). 3. Removed leaking water inlet valve assembly from refrigerator (1 screw). 4. Remove water inlet tube (loosen nut) and tube back to refrigerator (pull from water valve after remove cotter pin washer). 5. Detach two electrical wire harnesses. 6. Install new water inlet valve as... read more

The factory door gasket was split and needed replacing

  • Customer: Carl from LAKE WYLIE, SC
  • Difficulty: Very Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 4 of 4 people found this instruction helpful
I pulled the gasket off and installed the new one. It was very easy. All I had to do was to push the new gasket in place in the grooves in the door. The gasket I received was identical to the one I replaced. read more

Replace Thermistor in back of freezer

  • Customer: Scott from JUPITER, FL
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers
  • 4 of 5 people found this instruction helpful
Turn off power, remove upper and lower drawers (may need to open upper refrigerator doors to remove large freezer bin,) remove drawer supports (upper and lower), remove rear freezer panel (trick is to loosen 4 screws on fan bumpout to get the panel to come free from the freezer side wall), test thermistor with multimeter (should have continuity or near zero ... read more