Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Fred
January 23, 2020
When oven is warm up it over heats. What can cause that
Please advise
Thank you
For model number HBL5451UC
Hello Fred, thank you for your question. The most common cause of that issue is the sensor, PartSelect Number: PS10057828. I hope this helps.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
First, cut the power and remove the oven from the cabinet.
The bake element is accessible from the back and sits in a drawer.
As someone else said, you have to use pliers to bend the cover of the drawer, you will make some damage to the cover, but there is nothing you can do about it.
Make a note of what w
... Read moreire goes to the right and to the left so you can plug them back like it was before.
When you replace the bake element, make sure you insert it in the straps so it won't wiggle when it heats.
To close the cover that you bent, you will need a helper and push really hard.
Replace facia panel. Turn off power to the oven. Remove oven control knobs by inserting finger tips under each side of the knob and pulling. Open oven, remove mounting screws. slide the oven out a few inches to allow clearance for the removal of the facia panel. Remove 3 torx screws under the bottom of the facia panel. The wiring harness
... Read morees for the LED temperature display and touchscreen are very short and must be disconnected in order to remove the facia. Slowly pull out the bottom of the facia panel taking care not to damage the wiring harnesses. Locate the wiring harness connections and disconnect. Lift the facia panel up and away from the oven. Carefully remove the LED temperature display from the back of the facia panel touch screen. Installing the new facia panel: The LED temp display wiring harness is very short and difficult to connect with the LED display installed on the new facia touchscreen panel. For this reason connect the wiring harness to the LED temp display before installing it in the new facia. Once the wiring harness is connected to the LED display, place the facia panel in position and reach under, align the LED display with the touch screen panel mounts and snap into place. Connect the touchscreen harness, position the facia panel and replace the three screws. Secure the oven in place, replace the knobs, and turn on the power.
