This assembly is the door shelf end cap set for the left and right side of your refrigerator. The function of the door shelf end cap is to attach the inner door liner to the door shelf rail. This will then hold the door shelf rail in place and keep it stable. To make this installation you may need a pair of pliers, other than that the par...Read morets will easily snap in and out of place. These pieces are white and measure almost 2 inches long, 1 inch high, and 1.5 inches wide.
This part is found in freezers. The stud may have broken over time and may no longer be supporting the shelf. If your shelf is not staying in place or you are not able to adjust heights, it may be due to the support being broken. To complete this repair, you will need to open the fridge and remove the drawer and the shelf. To remove the o...Read moreld stud, you will need a 3/4-inch wrench to twist it off. The new part should push into place and will need to be turned with your wrench to be secured into place.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
end cap broke
3 of 4 peoplefound this instruction helpful.
GEORGE from WEST LIBERTY, OH
Really Easy
Less than 15 mins
slid one end cap into slot and pulled into place. Put other end cap into cross bar and put other end of cross bar on to other end cap proceeded to put other end cap in to other slot in door and pulled into place. Job complete Job took less than three minutes.
Was this helpful?
Thank you for voting!
Ice crystals formed near gasket.
2 of 2 peoplefound this instruction helpful.
James H from KNOXVILLE, TN
A Bit Difficult
1- 2 hours
Socket set
Removed the freezer door which had an electrical cord routed through the lower hinge with a disconnect under the freezer. Job works better with two people. Working the gasket into place was a little tricky at the corners. The putty knife was helpful. Make sure door is not warped when replaced on freezer. If warped slightly the door c
... Read morean be twisted to make gasket fit evenly bottom to top on front edge. Hope this helps DIY folks.
Read less
Was this helpful?
Thank you for voting!
The end cap of the bottom shelf of my freezer was broken
1 personfound this instruction helpful.
Kathleen from SELDEN, NY
Really Easy
Less than 15 mins
Screw drivers
Finally after a few years of putting the shelf back on and balancing food on it I looked up the part. The clips came in a few days. I used a screwdriver to pop off the old piece. I lined up the clip and pushed it in.! I am sooo glad I purchased this.