Models
>
FCM15SMAWH
FCM15SMAWH General Electric Freezer - Overview
Sections of the FCM15SMAWH
[Viewing 4 of 4]Keep searches simple, eg. "belt" or "pump".
Power Cord
PartSelect #: PS759476
Manufacturer #: WR23X10300
This heavy-duty cord has a three-pronged plug (2 electrical, 1 grounding). The power cord supplies power to your refrigerator, allowing it to keep the contents inside cool. There could be an issue wit...
$29.54
In Stock
R134 DRIER
PartSelect #: PS12727537
Manufacturer #: WR86X25269
The filter dryer filters refrigerant that travels through the sealed system of the refrigerator.
$62.27
In Stock
PTC Start Relay
PartSelect #: PS287975
Manufacturer #: WR08X10034
Connects into the Capacitor. This part boosts the compressor and shuts off as soon as the motor gets up to the required speed.
No Longer Available
Questions And Answers for FCM15SMAWH
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Common Symptoms of the FCM15SMAWH
[Viewing 1 of 1]Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Moldy Gasket
This freezer was given to me by a neigbor. It had set closed/unplugged for over a year. The gasket was so moldy I couldn't clean it. Unplug the freezer! I removed the old gasket pins using needle nose pliers. There were about 50 plastic pens holding the gasket and inside cover of the freezer lid (chest freezer) The plastic pens were
... Read more
difficult to remove. The insulation was wet so I braced the lid open and let the insulation dry for a couple of days. When the insulation was dry I attached a plastic pen at each corner of the gasket and then placed pens at even intervals around the rest of the gasket.. None of the holes lined up past the 3rd hole so I used a punch to make the necessary holes. The instructions say to put a bead of silicone gel around the outer edge of the gasket. I haven't done that yet but plan to do that last step.
Read less
Parts Used:
-
Ouida from Huntsville, AL
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Pliers, Screw drivers
4 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
freezer not keeping frost free & gasket was hard
Ordered from PartSelect, got the gasket very quickly && even has the best cost over SEARS & 3 other places. I followed the instructions in the pkg. but it may be that the freezer is too old or the lid needs to be readjusted. Who knows but would suggest this company to anyone for parts! Thanks again!P.S. it took longer than most
Parts Used:
-
Joyce from Citrus Heights, CA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
1 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!