Quick Question!

Have you ever purchased from PartSelect.com before?

Models > FCM15CPAWH

FCM15CPAWH General Electric Freezer - Overview

Get Parts and Repair Help for FCM15CPAWH

If you know the freezer repair part you need, you can browse the list of all parts on the FCM15CPAWH, or you can search by name or part description. You can also find your part by where it is located on the FCM15CPAWH by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the FCM15CPAWH

[Viewing 3 of 3]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$14.23

LOCK KEY

$15.21

PLUG DRAIN

$6.59

PLUG DRAIN EXTERIOR

$146.10

Gasket

$142.89

Inner Lid Panel - White

Not the complete lid.

$33.63

COLD CONTROL KNOB

$107.26

PTC Start Relay

Connects into the Capacitor. This part boosts the compressor and shuts off as soon as the motor gets up to the required speed.

$53.88

CAPACITOR

$5.08

LEVELNG JACK

$85.44

HANDLE CHROME

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Moldy Gasket

  • Customer: Ouida from Huntsville, AL
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers
  • 4 of 5 people found this instruction helpful
This freezer was given to me by a neigbor. It had set closed/unplugged for over a year. The gasket was so moldy I couldn't clean it. Unplug the freezer! I removed the old gasket pins using needle nose pliers. There were about 50 plastic pens holding the gasket and inside cover of the freezer lid (chest freezer) The plastic pens were difficult to remove.... read more

Two of the two leveling jacks of this old refrigerator were missing and had to be replaced.

  • Customer: Bruce K from RESTON, VA
  • Difficulty: Very Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required:
  • 1 of 1 people found this instruction helpful
I ordered four leveling jacks from this site for the refrigerator using a slightly different model number (my model was not listed). I assumed that the jacks all had the same shaft diameter and thread size. However, it turned out that the two front jacks had half-inch shaft diameters. It could be that originally there were rollers in front. The two rear jac... read more

freezer not keeping frost free & gasket was hard

  • Customer: Joyce from Citrus Heights, CA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 1 of 5 people found this instruction helpful
Ordered from PartSelect, got the gasket very quickly && even has the best cost over SEARS & 3 other places. I followed the instructions in the pkg. but it may be that the freezer is too old or the lid needs to be readjusted. Who knows but would suggest this company to anyone for parts! Thanks again!P.S. it took longer than most read more