My Orders
EW27EW65PSC Electrolux Wall Oven - Overview
Diagrams for EW27EW65PSC
See every part. Know exactly what you need.
Enter a part description. DIY Heroes keep it simple, eg. "belt" or "pump".
Search filter:
Clear Filter
Your search term must have 3 or more characters.
$40.60
In Stock
Main Terminal Block Kit
Part #5304409888
Terminal block kits are also known as terminal boards, or terminal strips, and they are found in a wide variety of household appliances. Most often in ranges, wall ovens, and dryers. This kit attaches the power cord to the inner wiring of your appliance. If the terminal block is faulty, your appliance will not get the power it needs to op...Read moreerate properly. When removing the old block pay close attention to the wire placement, this will make installing your new part much easier. If you notice any of the wires or wire terminals are corroded or damaged they will also need to be replaced.
Read less
$53.85
In Stock
Temperature Sensor
Part #5304504897
The temperature sensor, also known as an oven probe, helps measure the temperature within the oven cavity. If your oven is too hot, not heating evenly, has little to no heat when baking, or flashing F3/F4 error messages on your control board, you may need to replace this part. This part measures 6" long and is made of metal. Please make s...Read moreure to disconnect the power to your oven range before starting this repair. This temperature sensor is a genuine OEM part.
Read less
$26.35
In Stock
$56.05
In Stock
Limit Thermostat For Cooling Fan
Part #318578506
This authentic OEM high-limit thermostat, also known as a limit switch or cooling fan thermostat, serves as a safety feature to prevent the oven from overheating. It monitors the temperature inside the oven and activates the cooling fan when the temperature exceeds a certain limit. The cooling fan helps dissipate heat and maintain a safe ...Read moretemperature. The high-limit thermostat is usually situated inside the top panel. If the high-limit thermostat is broken or faulty, the cooling fan may fail to turn on, leading to excessive heat buildup inside the oven. You might also notice that your food cooks unevenly since the oven struggles to maintain the desired temperature. In some cases, if the high-limit thermostat is completely non-functional, the oven may not heat up at all. You can test the sensor at room temperature by measuring the resistance between the two prongs at the end of the sensor connector. The resistance should read approximately 1080 - 1090 ohms at room temperature. To access the thermostat, refer to your user guide for detailed instructions. Generally, you need to ensure the power is disconnected at the breaker, lift the top panel on its hinges, remove the screws on the plate under the burners, take out the burners and plate, disconnect the wires from the old thermostat, and remove the mounting screws to release it. Please note that the replacement part is sold separately from the cooling fan.
Read less
$31.47
In Stock
Door Spacer
Part #318165800
$41.17
In Stock
Convection Fan Blade
Part #318398302
This convection fan blade is designed for use with various makes and models of range and oven and is sold as an individual part. Made of metal and measuring approximately 4.75-inches in diameter, this genuine OEM fan blade works with the convection motor to circulate and distribute heat evenly throughout the oven. If your oven is not gett...Read moreing hot enough or the heat is not circulating properly, or if the fan blade in your oven has become warped, damaged, or chipped, it needs to be replaced immediately. To replace the fan blade, disconnect your range from the power and locate the fan assembly. With the appropriate screwdriver and wrench, remove any assembly covers and the securing nut from the blade. Once the nut is removed, install the new blade and secure it and re-install the cover.
Read less
$33.90
In Stock
Fan Blade Retainer Nut
Part #316136600
This fan blade retainer nut in your oven secures the fan blade onto the motor shaft, preventing it from coming loose during operation. You can typically find it at the back of your oven behind a cover. If you notice that the fan blade becomes wobbly or does not rotate smoothly, or your oven starts to make rattling or scraping sounds, the ...Read morenut may be damaged. If the fan blade cannot spin properly, your food may cook unevenly. Your oven will also work harder and consume more energy to maintain the desired temperature. To access the nut, you will need to remove the back panel of your oven. Remove any screws or release any clips holding it using a screwdriver. To remove the nut itself, you will need either a wrench or a pair of pliers to loosen it from the motor shaft. The fan blade is sold separately from this genuine OEM nut.
Read less
$53.85
In Stock
Light Bulb
Part #318946500
This replacement light bulb provides clear illumination to improve visibility during appliance operation. It is commonly replaced when the original bulb burns out, flickers, or no longer produces adequate light.
$151.28
In Stock
Bake Element - 1450W
Part #318902502
This hidden bake heating element provides the primary heat source for baking in electric wall ovens and ranges. Concealed beneath the oven floor, it delivers even heat distribution while allowing for easier cleaning of the oven cavity. Rated at 1450 watts, this durable element is designed for 27-inch built-in ovens and compatible applianc...Read moree types, including wall ovens, microwave/oven combos, and electric ranges. Common signs of a failing element include weak heating, uneven baking, or the oven not heating at all. Installation is straightforward and can typically be completed with basic tools.
Read less
No Longer Available
LAMP ASSEMBLY
Part #139001800
This halogen lamp assembly in your oven illuminates the cavity and is often located near the back wall or on the ceiling, so that you can easily monitor the cooking progress of your food. It consists of a bulb and a protective cover. To check if it is broken, look for a burned-out or broken bulb, a cracked or missing cover, or loose conne...Read morections. If the bulb does not light up despite being functional, there may be an issue with the assembly. Not replacing a damaged assembly can make it difficult to check your food or identify heating or spillage issues, so prompt replacement is essential. To remove your lamp assembly, first turn off the oven and allow it to cool down to avoid burns or electrical shock. If there is a separate power switch for the lamp assembly, turn it off. Alternatively, switch off the power at the circuit breaker for complete safety. Consult your user guide to find the wire connection point for the lamp assembly. You may need to remove a small cover or access panel to access it. Carefully unplug or detach the wire from the oven. Once the wire is disconnected, you can remove the entire lamp assembly from its mounting location. This OEM replacement part comes with a covered bulb and a wire connector.
Read less
$53.28
In Stock
SWITCH
Part #808136601
$158.07
In Stock
ELEMENT
Part #5304523477
Manuals & Care Guides for EW27EW65PSC
Click to downloadInstall
Installation Instructions
(1.13MB)
Specs
Product Specifications Sheet
(1.43MB)
Wiring
Wiring Diagram
(1.43MB)
Common Symptoms of the EW27EW65PSC
How this model fails, and the parts that fix it.
Little to no heat when baking
Fixed by
these parts
these parts
Show All
Element will not heat
Fixed by
these parts
these parts
Show All
Oven is too hot
Fixed by
these parts
these parts
Show All
Will Not Start
Fixed by
these parts
these parts
Show All
Oven not heating evenly
Fixed by
these parts
these parts
Show All
Little to no heat when broiling
Fixed by
these parts
these parts
Show All
Watch our pros, then fix it yourself.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!
View More