This genuine OEM halogen bulb provides bright, heat-resistant interior lighting for select wall ovens and ranges, making it easy to check cooking progress. Rated at 10 watts and 12 volts with a G4 bi-pin base, it’s a simple plug-in replacement for a dim, flickering, or burnt-out oven light. Designed for specific models, it restores clear visibility inside the oven for everyday cooking.
This is a burner head O-ring and is used in conjunction with your range cooktop. The purpose of the O-ring is to sit between the range cooktop and the burner head assembly. This part will create a seal,which will limit the risk of fuel leaks over time. Due to natural wear and tear this part may dry out or crack. If this happens, you will need to replace this part. We also reco
This oven door hinge assembly supports controlled opening and closing while helping the door remain properly aligned. Replace a worn or damaged hinge when the oven door no longer moves or sits as it should. Verify fit with your appliance before ordering.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Flame was not even all around.
5 of 5 peoplefound this instruction helpful.
Keith from MIAMI, FL
Very Easy
Less than 15 mins
Cleaned the brass ring and replaced the cap. New brass rings may be an improvement too.
Was this helpful?
Thank you for voting!
F2 Alarm and oven beeping
3 of 3 peoplefound this instruction helpful.
David from CAMILLUS, NY
Easy
15 - 30 mins
Screw drivers
Replaced relay board
Was this helpful?
Thank you for voting!
Replaced bottom relay control panel
2 of 2 peoplefound this instruction helpful.
David from BUENA VISTA, CO
Really Easy
30 - 60 mins
Screw drivers
First disconnected power to the oven at circuit breaker box. Then, Removed top front control panel, held by four screws exposed when top oven door is opened. Was able to move control up and out of the way without disconnecting. The relay control panel is visible on the right. I was able to reach all connectors with needle nose plie
... Read morers and then remove the panel with needle nose to release clips and use screw driver to gentle pry up. Installed new unit by attaching back connectors and then setting panel down onto clips. Finished with attaching front connectors. Reattach front control panel.