ER36D Dacor Range - Overview

The rubber feet, also known as the burner grate foot, is used on the bottom of gas burner grates for a range and cooktop. The rubber feet help the grates sit on the top of a burner cap properly and works to keep it leveled. This way you can place your pans and pots on an even surface. This part also prevents your burner grates from scratc...Read morehing and damaging the top of your stove. This can lead to friction and the paint on the stove top can chip. Make sure to unplug range from power source before installing this part.

Restore visibility inside or beneath a compatible cooking appliance with this low-voltage halogen replacement bulb. Rated at 12 volts and 20 watts, it features a G4 two-pin base that fits into the appropriate socket. A burned-out, flickering, cracked, or darkened bulb may indicate that replacement is needed. Before installation, disconnec...Read moret the appliance from power, let the bulb and surrounding surfaces cool, and avoid touching the new bulbs glass directly. Confirm the electrical rating and socket style before purchase.

Help the oven heat more evenly with this temperature sensor for select ranges, wall ovens, and microwave oven combos, a bad sensor can send the wrong heat reading, which may cause poor baking, long preheat times, or heat that does not shut off when it should, disconnect power before repair, use the exact model number to confirm fit.

A burner that clicks without lighting?or does not spark at all?may have a problem in the ignition system. The replacement spark module provides the electrical pulses that travel to the burner electrodes and ignite the released gas. Replacement may be needed when sparks remain weak, delayed, or absent after the electrodes, switches, wiring...Read more, burner caps, and gas supply have been checked. Several faults can cause the same symptoms, so proper testing is important. Turn off electrical power and close the gas valve before service. Reconnect wires exactly as shown in the appliance diagram, and check for gas leaks using an approved method before operating the appliance.