Restore visibility inside or beneath a compatible cooking appliance with this low-voltage halogen replacement bulb. Rated at 12 volts and 20 watts, it features a G4 two-pin base that fits into the appropriate socket. A burned-out, flickering, cracked, or darkened bulb may indicate that replacement is needed. Before installation, disconnec...Read moret the appliance from power, let the bulb and surrounding surfaces cool, and avoid touching the new bulbs glass directly. Confirm the electrical rating and socket style before purchase.
Help the oven heat more evenly with this temperature sensor for select ranges, wall ovens, and microwave oven combos, a bad sensor can send the wrong heat reading, which may cause poor baking, long preheat times, or heat that does not shut off when it should, disconnect power before repair, use the exact model number to confirm fit.
An oven that suddenly stops heating may have an open high-limit switch. This safety device monitors heat near key electrical parts and interrupts power if the temperature reaches its set limit. Its 220?F rating must match the appliance design. A tripped or failed switch can prevent normal operation, but it should not be replaced without c...Read morehecking why the area became too hot. Inspect the cooling fan, vents, wiring, connectors, and control system first. Turn off the circuit breaker and confirm that no power is present before service. Let all surfaces cool, transfer the wires carefully, and install the switch in its original position.
See how others fixed this model. Time, tools, difficulty, and steps that lead to victory!View More
Search repair tips from other customers using simple keywords like "replace", "fit", "remove", "inspect". DIY doesn't mean you have to do it alone!
Search filter:
Clear Filter
Your search term must have 3 or more characters.
My hinge receptacle was groove was worn away cause hinge to get jam
2 of 2 peoplefound this instruction helpful.
JEFFREY from KNOXVILLE, TN
Difficult
30 - 60 mins
Screw drivers
Pulled oven about 6 inch out from cabinet. Then remove side cover piece. Push out hinge receptacle with screwdriver. Replace with new hinge receptacle and reverse process
Purchased a screw extractor set from the local Ace Hardware (SpeedOut). Be sure and carefully follow the screw extractor instructions as written (counterclockwise turn). Removed old screws and replaced them with new screws supplied by PartSelect.