Quick Question!

Have you ever purchased from PartSelect.com before?

Models > E32AR75FPS2

E32AR75FPS2 Electrolux Refrigerator - Overview

Get Parts and Repair Help for E32AR75FPS2

If you know the refrigerator repair part you need, you can browse the list of all parts on the E32AR75FPS2, or you can search by name or part description. You can also find your part by where it is located on the E32AR75FPS2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the E32AR75FPS2

[Viewing 4 of 4]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$8.59

LIGHT BULB

This light bulb is used on the inside of your refrigerator or freezer. It is blue in color.

$86.48

GASKET-DOOR

This white door gasket is used to seal the freezer door when closed. Door gasket ONLY. This gasket can be used on stand alone refrigerators as well.

$45.22

Evaporator Fan Motor with Wire Harness - 115V

This evaporator fan motor is 115V. If you notice that your freezer is noisy or is too warm, you may need to replace the evaporator fan motor. This package comes with the evaporator...

$29.21

Evaporator Fan Blade

This evaporator fan blade is a genuine OEM part that is sourced directly from the manufacturer. The evaporator fan blade circulates air through the refrigerator to control the amount of cold air goes that goes to internal compartments of the unit. It may need to be replaced if the fridge is noisy or not cold enough. This part is made of plastic and is sold individually. It will be necessary to disconnect power to the refrigerator and empty the freezer compartment of the refrigerator. The tools needed to complete this repair are a 1/4 inch nut driver and a pair of needle nose pliers.

$6.34

SCREW-SHOULDER

Sold individually.

$13.10

Air Filter

$9.91

Adjustable Leveling Foot - Black

This part could be found underneath a fridge, dryer, or freezer. The original foot may be cracked, broken, or perhaps missing altogether. If you notice the appliance is uneven to t...

$75.68

Water Filter Base

$39.90

Dairy Door

$7.82

Single Gasket Retainer Clip

This genuine OEM freezer gasket retainer clip is used on refrigerator freezers, and connects the inner door panel and door gasket to the outer door panel. The gasket is the rubbery strip that seals the space around the edge of the door to keep warm air out of the freezer. When the gasket is not working properly, you may notice an excessive frost buildup or reduced cooling. If the gasket is hanging loosely from the door, the issue could be with the retainer, or the clip fastening the retainer to the gasket, and it should be replaced.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Ice and frost were forming in a frost free freezer

  • Customer: Louise from Ocala, FL
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required:
  • 51 of 69 people found this instruction helpful
The old gasket was obviously gapping, partially from age and partially from damage during a move. To make the repair, I loosened the screws that are under the gasket and hold it in, but did not remove them. Once all were loose, I removed the old gasket, then starting at the top, ran a thin bead of food grade RTV under the portion of the door that captures ... read more

No water flow to in-door water/ice dispenser

  • Customer: Richard from St. Louis, MO
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 25 of 28 people found this instruction helpful
Unscrewed the water line cover. Removed the platic case around the water filter base. Everything went well until I tried to remove the two water hoses. After I finally figured out that I had to push in the release washer while pulling the hoses out, things went well. Unfortunately it took several hours of wasted time and several searches on the internet ... read more

Freezer thawing at about 20 degrees

  • Customer: Nathan M. from Bunnell, FL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 13 of 13 people found this instruction helpful
Turned freezer off at themostat and unplugged freezer. Removed 2 screws at front 2 at the back and 2 at the top. Lowered top cover and removed evaporator fan bracket (2 more screws) removed themostat capulary tube( 1 screw and bracket) then unplug fan motor. Removed motor from bracket (2 screws). Put on new fan motor then removed fan blade from old motor ... read more