Quick Question!

Have you ever purchased from PartSelect.com before?

Models > E30WD75GSS2

E30WD75GSS2 Electrolux Warming Drawer - Overview

Get Parts and Repair Help for E30WD75GSS2

If you know the warming drawer repair part you need, you can browse the list of all parts on the E30WD75GSS2, or you can search by name or part description. You can also find your part by where it is located on the E30WD75GSS2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your warming drawer. We’ve also included any installation videos we have for E30WD75GSS2 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the E30WD75GSS2

[Viewing 4 of 4]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$34.18

Temperature Sensor

The oven temperature sensor for your range may also be called a probe. The quick connect on this part may differ than your original piece. If the temperature sensor does not fit yo...

$6.54

SCREW

$7.00

SCREW

$7.86

SCREW

$6.45

SCREW

$107.56

HANDLE

$19.46

SPACER

$8.57

SPACER

$50.21

Warming Drawer Heating Element

$20.18

CLEANER-COOKTOP

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not heating to desired temperature

  • Customer: Dan from Bellevue, ID
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 110 of 166 people found this instruction helpful
Replaced clock control by removing surface burner control knobs and plastic nuts, and then the cover over the oven control. Two screw hold the clock in place, after removal and disconnecting the plug-in you can reinstall the new clock control. The Heat Sensor inside the oven will also need to be replaced. It is located inside the oven and attached with tw... read more

Oven would not maintain correct set temperature.

  • Customer: Barbara from RAINBOW CITY, AL
  • Difficulty: Very Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 4 of 6 people found this instruction helpful
Removed electrical connector and two screws. Attached the electrical connector to the new probe and attached with the two screws. read more

Improper temperature when baking.

  • Customer: Lorenza from Rowlesburg, WV
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Moved the stove away from the wall, unhooked the electric cord and the gas pipe. In the oven, undid the two screws holding the probe. Removed two screws and removed the electrical cover panel from the stove back, disconnected the quick connect to the probe and pulled the probe from the oven. Reversding the proceedures, put the new probe into the oven, hooke... read more