Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This broiler pan and roasting rack set is designed to help reduce mess while cooking by allowing grease to drain away from food. Its durable porcelain-coated construction stands up to high temperature...
This hex nut is an authentic Whirlpool part that is sourced directly from the original equipment manufacturer, and will fit a variety of appliances including ovens, microwaves, refrigerators, air cond...
This part is sold individually. This nut can be found in various appliances including a dishwasher, air conditioner, washer, dryer, range/cooktop, oven, freezer, range hood, and refrigerator. There is...
Solution: assy, idler lever (#37001287) the trick was to remove the top cover as there are no exposed screws 1. Insert a putting knife in the middle of the gap between the top cover and the front panel. Slide the putty knife to the left and then right. When you hit something, it is a clip. Use the putty knife to depress the 2 lo
... Read morecking clips. Lift up the top cover. 2. Remove the front panel ( 2 screws, on each side and some electrical spade connectors) 3. Remove the blower duct (3 screws from inside the drum) 4. Remove the blower panel (9-screws). Set aside. 5. Remove belt tension from idler-assy 6. Disconnect motor harness connector from motor. 7. Rotate blower assembly counter-clockwise to remove from dryer. 8. Replace idler assy.
