CCGS995SEL1SS General Electric Range - Overview

This burner grate foot, also known as a bumper, is an authentic OEM replacement part for your range. It is a small black rubber component that acts as a buffer between the metal grate and the surface of the cooktops to prevent scratches and damage to the cooktop. It also stabilizes the burner grate and prevents it from shifting or sliding...Read more, which reduces the risk of accidents or spills. These small components can easily fall and become lost while cleaning or wear down over time. Inspect each of the feet and ensure that you order the correct amount for your range. Each burner grate foot is sold separately.

This burner cap is for your gas range, and acts as a cover for the burner head. It is black in color and just over 3 inches in diameter. If your old burner cap is damaged or missing, this is the part that will replace it. This is an OEM part sourced directly from the manufacturer and is sold individually.

This is a replacement burner cap for your gas range or cooktop. The burner cap is found on the burner head, and prevents debris from getting into the head when it is not in use. The cap is black in color and is sold individually. It is a little more than 4 inches in diameter. To replace the burner cap, simply remove the damaged cap, and r...Read moreeplace it with the new one. No tools are required for this repair. This is an OEM part from the manufacturer.

This is a burner cap for your gas range. The cap acts as a cover for the burner head. If your old burner cap is damaged or missing, this is the part that will replace it. The cap is black in color and about 3 and a half inches in diameter. This is a quality OEM part sourced directly from the manufacturer. This cap is sold individually.

The light housing is also known as a lamp holder and is a part for the oven in your range. The function of this piece is to hold the bulb that will light up the inside of your oven. As per the manufacturer instructions, if your bulb has burnt out you must buy the bulb for this part locally. This light housing is roughly five inches high, ...Read morewith an outside diameter of roughly four inches by four inches. To install this part, you will need a Phillips screwdriver, a nut driver, and a pair of pliers.

This kit includes the sensor as well as the connectors. NOTE This sensor is 2" long.

This part is a replacement screw for your oven. It is made of black metal and is sold individually. This screw is approximately 1/4 inch in diameter and about 1/2 inch in length. It is designed to connect the different parts of your oven door. This part is an authentic OEM part sourced directly from the manufacturer.

This economic nut is a manufacturer-approved replacement part for your oven range. The nut can become worn down or stripped over time and need replacing. Make sure to disconnect power to the unit and wait until it cools before beginning this repair.

This spark module is a genuine replacement part for GE gas ranges, designed to generate the electrical spark that ignites the surface burners. As a key component of the ignition system, it ensures safe and reliable burner operation. Compatible with select GE models and certain ranges from Hotpoint, Haier, Monogram, and Kenmore, this part ...Read morerestores proper ignition when your range fails to light. Always confirm compatibility before installation.