Your coupon for will be reflected when you check out!
✖
Your coupon for
✖
Hello!
You're visiting the PartSelect site in U.S.
Would you like to shop on the Canadian site?
Stay on this site
Go to Canadian site
✖
Model Number Locations
1Select Category Type
Select Category Type
2Select Product Type
Select Product Type
3Select {MODEL} Type
Select {MODEL} Type
Sample Model Number Tags
Model numbers can be made up of numbers (1005400, for example) or a combination of letters and numbers (LAT1000AAE). The model number will most likely appear on either a paper sticker or a metal plate. Your appliance's model number tag may look similar to the sample model number tags shown here (model number highlighted in yellow):
Model has been saved to My Models. If you're not signed in, your lists are available on this device and will expire within 30 days.
Model has been saved to My Models.
This propeller fan is designed to maintain optimal airflow in air conditioning and heat pump systems, ensuring efficient heating and cooling performance. It circulates conditioned air evenly throughou...
This DC motor assembly is a genuine replacement component designed for the outdoor unit of select LG ductless and window air conditioners. It powers the fan responsible for circulating air over the co...
Remove the main power disconnect. Remove the top cover and the fan-side side panel. Disconnect the thermister from the main circuit board located under top panel. Remove the two thermister sensors from the holders attached to suction piping. Install the new thermisters and reconnect the harness to the circuit board. Reinstall top cover an
... Read mored side panel. Reinstall main power disconnect. Verify that error code has cleared. Operate the system normally.
Download PDF Multi Air Conditioner SVC Manual for LMU187HV,,, Disconnect the Power,,, Remove cover of the Outdoor Compressor, Remove black cover to the electronics board.. Find the Red Plug-in to the existing Suction Pipe Thermistor, replace with the new one, match each sensor (2) follow the leads one by one, remove the old attach the new
... Read more ones... Replace covers then the Disconnect & Waa-Laa,,, Fixed
Removed front, rear and side panel. matched up connector of old motor to new. unplugged old harness and plugged in new motor before, I installed it to see if it worked. Ran and sounded great. Took old motor off and replaced with new. All good.
