This manufacturer-approved air filter system for refrigerators eliminates odors and any impurities. It does this by neutralizing and removing odor-causing molecules. For best results, it is important ...
This screw is used in refrigerators. The screw can be loosened or tightened with a Phillips-head or square-head screwdriver. This screw is used to secure the refrigerator handle to the refrigerator do...
This part could be found underneath a fridge, dryer, or freezer. The original foot may be cracked, broken, or perhaps missing altogether. If you notice the appliance is uneven to the floor or wobbling...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Margaret
January 17, 2024
How do I remove the water filter? Is it threaded?
For model number 25370349412
Hello Margaret, thank you for writing in. Our research has found, part number PS479902 is the replacement water filter for your model. We also found some installation instructions for you. To Replace your Kenmarepure! TM
Water Filter:
29
It is not necessary to turn the water supply
off to change the filter. Be ready to wipe up
any small amounts of water released during
the filter replacement.
1. Turn Off the ice maker power switch.
2. Remove the filter by pushing on the end/
face of the filter.
3. Slide the old water filter cartridge straight
out of the housing and discard it.
4. Unpackage the new filter cartridge. Using
the alignment guide, slide it gently into the
filter housing until it stops against the snapin connector at the back of the housing.
5. Push firmly until the cartridge snaps into
place (you should hear a click as the
cartridge engages the snap-in connector).
6. Pressa drinking glass against the water
dispenser while checking for any leaks at
the filter housing. Any spurts and sputters
that occur as the system purges air out of
the dispenser system are normal.
7. After filling one glass of water, continue
flushing the system for about four minutes.
8. Turn On the ice maker.
9. Press and hold the Water Filter button on
the Ice & Water Dispenser control panel
for three seconds. When the display
changes from Red to Green, the status has been reset. We hope this helps.
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
removed fan unit from frig and installed new motor and then replaced back in frig. No tools needed. need to unplug unit and take apart and put new motor in the unit and then plug back in.