Surface Burner Switch

PartSelect Number PS2077123

This switch controls the stove top surface burner and has a double-flat shaft.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Cooktop element not heating.
  • Will not start.
  • Compare At

    $45.92
  • You Save

    $7.65
  • Your Price

    $38.27
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.7 / 5.0, 4 reviews What's this?
1-4 of 4
 

14 of 20 people found this instruction helpful

Parts Used

  • Surface Burner Switch

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsNutdriver

CustomerLarry from Hampton Cove AL

Old switch had shorted and burned out

This was a range top. i removed the 12 hex machine scews holding on the top, then removed the two star screws holding the old switch. there were fore wire that had fitted on tabs. Hooked them to the new swtch and reassembeld. Easy repair since i could lift the unit out without disconnecting main cables. Replacement range would have been oveer $1000. Psrt was under $40 and delivered in a matter of days.

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 10 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers, Wrench set

CustomerThomas from Grant NE

Surface burner switch failed, and so did red light indicator.

I disassembled the stove top and replaced the components.

Help other customers find the most helpful instructions.

Were these instructions helpful?

6 of 17 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsNutdriver, Screw drivers

CustomerJim from Garberville CA

Two burners went out

took stove out of counter, propped up with supports, left wires connected. dislmantled stove (no priorexperience) turned each burner on, checked to
see if power reached burner with simple 110 220v
tester, found burners did noty get power in all positons so burners must be ok., unplugged burner
control units to get part numbers, no numbers, went
to your site and found diagram with part number. , ordered parts, they came in 3 days, re-assembled
and unit worked fine.
Easy repair, new flat stove top costs 1200. fixed unit for less than 100. parts couple of hours of my time.
100. with about 4 hrs ofmy time total.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 4 people found this instruction helpful

Parts Used

  • Surface Burner Switch

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsSocket set

CustomerGail from Sedona AZ

Switch for burner, when turned on, would set breaker to off

Lifted stove top from counter, removed screws securing glass top, removed screws from switch housing. Removed color coded wires from old switch, one at a time, and secured them to the new switch. Put it all back together and just like new. Probably saved $200 service call.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-4 of 4