Models > CCR567W Maytag

CCR567W Jenn-Air Range - Overview

Get Parts and Repair Help for CCR567W

If you know the range repair part you need, you can browse the list of all parts on the CCR567W, or you can search by name or part description. You can also find your part by where it is located on the CCR567W by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CCR567W [Viewing 1 of 1]

$2.70

Screw

This screw is sold individually.

$39.80

Surface Burner Switch

This switch controls the stove top surface burner and has a double-flat shaft.

$29.11

Indicator Light

$23.63

LIGHT BOX

BURNER BOX

WIRE CABLE ASSY

CROSSBAR, ELEM SUPPOR

PLATE, SWITCH MTG.

CROSSBAR, ELEM SUPPORT

WIRE, PILOT LIGHT

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

old switch had shorted and burned out

  • Customer: Larry from Hampton Cove AL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 13 of 19 people found this instruction helpful
This was a range top. i removed the 12 hex machine scews holding on the top, then removed the two star screws holding the old switch. there were fore wire that had fitted on tabs. Hooked them to the new swtch and reassembeld. Easy repair since i could lift the unit out without disconnecting main cables. Replacement range would have been oveer $1000. P... read more

switch for burner, when turned on, would set breaker to off

  • Customer: Gail from Sedona AZ
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Socket set
  • 1 of 4 people found this instruction helpful
Lifted stove top from counter, removed screws securing glass top, removed screws from switch housing. Removed color coded wires from old switch, one at a time, and secured them to the new switch. Put it all back together and just like new. Probably saved $200 service call. read more

Surface Burner Short

  • Customer: John from San Antonio TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set
  • 0 of 0 people found this instruction helpful
Removed the cook top from the counter. Removed the switch housing and then the switch. Found a match and ordered. Part came in 2 business days. Once I put together the housing and connected the wire housing the burner worked perfect. The downdraft fan remained on. Placed a call to Jenn Air service and was asked to disconnect the fan switch. There must ... read more