Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS2083515
This indicator light illuminates, alerting you as to when the oven or stovetop is operating.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This clip is sold individually. It is used to clip down the indicator light on an oven or stovetop.
Removed the two screws holding the switch/indicator lights panel in place. After removing the two wires from the old indicator light, i removed the broken light, installed the new one, and reconnected the wires. It was then I discovered there was a spring clip that holds the indicator light in place, it had fallen into the area where the filter is kept. I had to remove the wires again, install the clip, reconnect the wires, and install the two screws holding the light panel in place. It would have been helpful to have a short description of the process included, which would have eliminated the need to remove the wires a second time to install the spring clip. The clip is essential to hold the indicator light in position and prevent it from moving.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Turned off the power. Removed the assembly with two screws then removed the switch with two screws. Pulled off the wires. Put on the new switch and lights and reconnected the wires. Reattached the assembly. Turned on the power. All OK.
We removed all the screws in order to remove the top cooktop frame. Once we did, the bottom part of the cooktop fell! It was being held up by the vent that goes underneath. My son and I had to get underneath to push up while my husband tried to position the cooktop back over the counter top ledge. It was VERY heavy. This was difficult and needless to say, it fell a couple more times before we finally were able to keep it on the ledge. We had to turn off the electricity, pulled the element out and disconnected the two wires, installed the new light and then placed the cooktop cover back in place by screwing all the screws. We did test the light before screwing on the cooktop cover JUST in case...:) It worked!
I disassembled the stove top and replaced the components.
The switch did not fit in and had to be returned.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.