Models > CCE3530B

CCE3530B Jenn-Air Cooktop - Overview

Get Parts and Repair Help for CCE3530B

If you know the cooktop repair part you need, you can browse the list of all parts on the CCE3530B, or you can search by name or part description. You can also find your part by where it is located on the CCE3530B by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CCE3530B [Viewing 3 of 3]

$2.70

Screw

This screw is sold individually.

$40.74

Dual Surface Burner Switch Kit

This switch is used to operate the dual surface burner.

$39.80

Surface Burner Switch

This switch controls the stove top surface burner and has a double-flat shaft.

$60.64

Surface Element Kit with Limiter - 6"

This ceramic element kit comes with an overheat limit switch, two wires, and two wire connectors.

$15.11

Infinite Knob

Sold Individually.

$89.60

Radiant Surface Element with Limiter - 8"

$4.46

Infinite Switch Grommet

$105.05

Dual Radiant Burner Element with Limiter

$29.11

Indicator Light

$23.63

LIGHT BOX

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Outer element of dual element burner didn't work

  • Customer: Michael from Collierville TN
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Socket set
  • 78 of 104 people found this instruction helpful
Remove Ceran Galss top by removing hex screws below the rim. Also remove the two opposing screws in the center of the downdraft opening. Ceran top comes off easily now.
The instructions with the new switch were very poorly written, so here is how I got the new switch to work:
Attach the black wire(s) from the old switch (terminal 2) to the new sw... read more

replaced heating element on flat surface stove top

  • Customer: dennis from assonet MA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 19 of 27 people found this instruction helpful
I removed 4 screws and then lifted up the top it gave me access to the element I followed the direction that came with the element (very clear to follow) removed and installed the new element and it worked fine. Remember to unplug the stove if it is electric this is not in the instructions. read more

The repair itself was very easy. “How to connect” was very hard to get.

  • Customer: Igor from Campbell CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 14 of 19 people found this instruction helpful
The repair itself was very easy. “How to connect” was very hard to get.


To get access to the switch, unscrew 2 screws from each side of front panel and then 4 screws from the bottom of it (open the door first). Have a box or a small table about 30” high to use it as support for the front panel.

The end result (colors for the Righ... read more