Models > CCE3531B

CCE3531B Jenn-Air Cooktop - Overview

Get Parts and Repair Help for CCE3531B

If you know the cooktop repair part you need, you can browse the list of all parts on the CCE3531B, or you can search by name or part description. You can also find your part by where it is located on the CCE3531B by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CCE3531B [Viewing 2 of 2]

$2.70

Screw

This screw is sold individually.

$58.06

Surface Burner Switch

This switch controls the stove top surface burner and has a double-flat shaft.

$45.05

Dual Surface Burner Switch Kit

This switch is used to operate the dual surface burner.

$15.11

Infinite Knob

Sold Individually.

$60.64

Surface Element Kit with Limiter - 6"

This ceramic element kit comes with an overheat limit switch, two wires, and two wire connectors.

$4.46

Infinite Switch Grommet

$344.79

Glass Cooktop - Black

$105.05

Dual Radiant Burner Element with Limiter

$24.90

Indicator Light

$23.63

LIGHT BOX

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Outer element of dual element burner didn't work

  • Customer: Michael from Collierville TN
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Socket set
  • 76 of 102 people found this instruction helpful
Remove Ceran Galss top by removing hex screws below the rim. Also remove the two opposing screws in the center of the downdraft opening. Ceran top comes off easily now.
The instructions with the new switch were very poorly written, so here is how I got the new switch to work:
Attach the black wire(s) from the old switch (terminal 2) to the new sw... read more

replaced heating element on flat surface stove top

  • Customer: dennis from assonet MA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 17 of 24 people found this instruction helpful
I removed 4 screws and then lifted up the top it gave me access to the element I followed the direction that came with the element (very clear to follow) removed and installed the new element and it worked fine. Remember to unplug the stove if it is electric this is not in the instructions. read more

old switch had shorted and burned out

  • Customer: Larry from Hampton Cove AL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 13 of 18 people found this instruction helpful
This was a range top. i removed the 12 hex machine scews holding on the top, then removed the two star screws holding the old switch. there were fore wire that had fitted on tabs. Hooked them to the new swtch and reassembeld. Easy repair since i could lift the unit out without disconnecting main cables. Replacement range would have been oveer $1000. P... read more