The timer would quit in mid cycle. Spin did not drain the water in Permanent Press or Delicate cycles.

ApplianceMaytag Washer

ModelMAVT446AWW

Level of DifficultyA Bit Difficult

Time to do repair1- 2 hours

Age of Appliance1 - 4 years

Tools Pliers
Nutdriver
Screw drivers
Socket set

Dale From Benton, LA

Aug 18, 2011

5 out of 8 people found this instruction helpful

I opened the front of the machine. The clips had rusted. One broke and the others were very difficult to work with. I pried the panel open with a large screwdriver. I took the back panel off to access the water pump. I removed the back panel on the electricals to access the timer. To replace the timer I pried off the decorative cover. To get the knob off you have to squeeze in on the timer split shaft while pulling out on the know. This was the second hardest part. (The front panel access was the most difficult). After that the timer clip is easy to loosen and it slides a littel then pops out. Electrical connection was obvious. The motor sping was the next most difficlt part. The spring fits on the rear part of the motor which is most easily accessed through the rear panel used for replacing the water pump. The water pump has three screws holding it and two hose clamps that come off easily with a pair of pliers. Before removing the water pump, I had to tip up the machine and take the belt off. This was also pretty easy. Put it back together and works great again on all cycles.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Motor Pivot Spring

Part Number: PS2021807

$3.96
In Stock

Drain Pump

Part Number: PS2347193

$69.70
In Stock