Quick Question!

Have you ever purchased from PartSelect.com before?

Models > CAV2000AWQ

CAV2000AWQ Magic Chef Washer - Overview

Get Parts and Repair Help for CAV2000AWQ

If you know the washer repair part you need, you can browse the list of all parts on the CAV2000AWQ, or you can search by name or part description. You can also find your part by where it is located on the CAV2000AWQ by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for CAV2000AWQ parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$56.03

Transmission Pulley and Bearing Kit

Also known as Thrust Bearing Kit. This kit includes the pulley, washer, thrust bearing, 2 upper race washers and 1 lower race washer. These parts are NOT available separately - t...

$37.75

Suspension Springs - Kit of 6

$98.98

Hub and Seal Kit

This kit prevents water from leaking around the drive shaft and down to the bottom of the tub.

$35.11

Lower Bearing Assembly

$13.84

Flume Hose Kit

$48.62

Agitator Base

Base only. Top agitator sold separately.

$39.05

Lid Switch Kit

This kit includes the bracket, actuator, switch, screws and wire harness.

$28.94

Tub Seal Kit with Brass Ring

This seal helps prevent any leaking around the transmission of washing machines.

$74.75

Agitator Top

This part fits on top of the agitator base.

$389.71

Transmission and Seal Kit

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

washing machine was making alot of noise

  • Customer: David from Boca Raton, FL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Wrench set
  • 522 of 527 people found this instruction helpful
I found the water pump bearings were going bad from humidity. I replaced the pump with a new one and it runs quiet again. read more

One of the plastic hinge pins brroke

  • Customer: Allen from North Little Rock, AR
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 480 of 477 people found this instruction helpful
I used a flat screw driver to push in on the releases so I could raise the top of the machine. I then used a torx tool to remove both parts of the hinge, and then used a #2 phillips screw driver, on the new screws I'd also ordered, to re-attach both of the hinge parts. Every thing went just as anticipated. read more

Washer jumping in spin cycle (white flakes under the washer)

  • Customer: David from Butler, PA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 229 of 238 people found this instruction helpful
Unlug the AC cord,open the top from the front it snaps open with a little force and hinges on the back, remove the 2 screws on the front cover and take it off, tip the washer and remove the belt, take off the pump hose from the back (I removed the back cover also) and the little hose going to the basket. Remove the 6 springs and lift the complete drum out of... read more