Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS224009
NOTE: The charcoal filter cannot be cleaned. It must be replaced. This metallic vent hood filter collects grease particles in the air from cooking.
This part works with the following brands: GE, Hotpoint & Kenmore.
Follow directions in the manuel, but getting the grill off to get to the where the filter goes was very difficult, the springs kept poping around. Finally got together. This is the 2nd time I have replaced this grill, don't remember it being this difficult before.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Take 2 screws off on top of the microwave, remove the small grill, remove the old charcoal filter, replace it with the new one put the grill back on, that is it, very easy. I change the filter every 6 months.
remove 2 screws from top of grille; remove grille by moving it to the left and then away.remove old filter by lifting the front edge and then pull out, and replace it wih a new one using the reverse order of the above.replace grrille and screws.The repair is a 'no brainer'.
Had to pry the front top of mircowave open and bend down and force this carbon filter in on an angle .Had to call several numbers for instructions. Very awkward and ridiculous to put carbon filter in-besides, it should have come with one to start with!!
It was very easy to remove the old charcoal filter and insert the new charcoal filter(had done it before with with the replacement filter GE had included with the purchase).
Removed 3 screws.Removed grille assembly.Installed new charcoal filter.Installed new assembly.Installed 3 screws.
Remove two screws on the top of the grill. Slide the grill to the left and then pull straight off. Slide the filter in place. Replace grill and screws
I unscrewed two screws on top of the microwave, slid the part (which opens when the microwave is in use) to the left and put it aside. The old filter is then easily picked up and removed. I placed the new filter in the same spot. I repositioned the removed part in place, lining up the little tabs, slid it to the right, which automatically lined up for replacement of the screws. These directions were included with the new filter and it was very easy to follow. I can't believe anyone would pay someone else to do this simple task! I am a 67 year old female.
Replaced the filter cartridge.Problem solved.
GE microwave displayed the message that Charcoil Filter needs to be changed. I disconnected the unit and removed the top two screws then removed the top panel by sliding it gently to the left. Replaced the filter. And positioned it in the same way the old filter was installed. Replaced the top panel and screws, Connected the unit back and used the Menu option to reset the Charcoil Filter warning option.
I finally found the two screws to remove the fan opening. Once I did that I did not locate an OLD charcoal filter!! I just deducted there was never one in there, based on where the instructions said it should be located. I placed the new filter and let it "rest on an angle" as per the instructions I read from the diagram, and from the other peoples description online. I put the breaker back on and all seems fine!
First I removed the two screws that held the filter cover in place, lifted out the old and replaced it with the new filter. Put the filter cover back on and replaced the two screws that hold it in place, and it was done in less than 5 minutes.
I usually replace the charcoal filter in the Microwave one every 3 months. this light out looked confusing and complicated at first, however I was surprised how easy it was when you have proper tools and directions from fellow Do It Yourselfers.
Followed the easy directions that came with the replacement filter
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.