Models > DVM1850DMWW01

DVM1850DMWW01 General Electric Microwave - Overview

Get Parts and Repair Help for DVM1850DMWW01

If you know the microwave repair part you need, you can browse the list of all parts on the DVM1850DMWW01, or you can search by name or part description. You can also find your part by where it is located on the DVM1850DMWW01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. We’ve also included any installation videos we have for DVM1850DMWW01 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the DVM1850DMWW01 [Viewing 1 of 1]

$5.23

Halogen Light Bulb - 120V 20W

Sold individually.

$5.89

Light Bulb - 40W 130V

Sold individually.

$11.54

Light Socket - 250V 75W

$39.45

Drive Motor

This motor rotates the glass turntable in the microwave and accepts a D-shaped shaft.

$8.54

Glass Light Lens

$19.43

Secondary Door Switch

$8.54

Glass Turntable Coupler

This part accepts a D-shaped motor shaft.

$36.67

Grease Filter

This metallic vent hood filter collects grease particles in the air from cooking. Sold individually.

$34.18

Charcoal Filter

NOTE: The charcoal filter cannot be cleaned. It must be replaced. This metallic vent hood filter collects grease particles in the air from cooking.

$4.27

Flat Cab Mounting Bolt

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The turntable motor went out and was making a horrible sound when I started the microwave

  • Customer: Kim from Centerville GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 144 of 210 people found this instruction helpful
First I unplugged the microwave. :) Then, I removed the 6 screws found underneath the microwave, which allowed the bottom piece to hang down so I could see the turntable motor. I took the two screws out holding the motor in place and pulled the electric connectors off the motor terminals. Then I got the new part from PartSelect.com, replaced the electrical c... read more

Lens cracked and bulbs burned out

  • Customer: Mark from GRAND BLANC MI
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 106 of 140 people found this instruction helpful
First I removed the single screw holding the lens assembly in place. Then I lowered the assembly and tilted it until it came out. To remove the existing cracked glass lens there were four tabs bent down on it. By hand I lifted each tab just enough to remove the broken lens. I then replaced the broken lens with the new one and re-bent the tabs down by han... read more

Grinding sound when tray turned

  • Customer: Charles from Wall NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 80 of 84 people found this instruction helpful
Unscrewed bottom plate of microwave and two screws that secured motor. Disconnect wires. Reversed process when installing new motor. Couldn't have been easier. read more