Models > EMO4000JSS04

EMO4000JSS04 General Electric Microwave - Overview

Get Parts and Repair Help for EMO4000JSS04

If you know the microwave repair part you need, you can browse the list of all parts on the EMO4000JSS04, or you can search by name or part description. You can also find your part by where it is located on the EMO4000JSS04 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. We’ve also included any installation videos we have for EMO4000JSS04 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the EMO4000JSS04 [Viewing 2 of 2]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$5.23

Halogen Light Bulb - 120V 20W

Sold individually.

$6.98

Light Bulb - 40W 130V

Sold individually.

$11.54

Light Socket - 250V 75W

$6.62

FUSE

$8.54

Glass Light Lens

$44.62

Drive Motor

This motor rotates the glass turntable in the microwave and accepts a D-shaped shaft.

$8.54

Glass Turntable Coupler

This part accepts a D-shaped motor shaft.

$19.43

Secondary Door Switch

$42.29

Grease Filter

This metallic vent hood filter collects grease particles in the air from cooking. Sold individually.

$34.18

Charcoal Filter

NOTE: The charcoal filter cannot be cleaned. It must be replaced. This metallic vent hood filter collects grease particles in the air from cooking.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Microwave completely stopped working

  • Customer: Kim from Cliffside Park NJ
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 263 of 345 people found this instruction helpful
Turned out the issue was easily solved by replacing a single, inexpensive fuse.

First off, UNPLUG THE MICROWAVE.

The fuse is located under the plastic grill at the top of the microwave. It's held on by two screws. Once you've removed the screws and taken off the plastic grill, you go to the right side of the microwave and remove an... read more

The turntable motor went out and was making a horrible sound when I started the microwave

  • Customer: Kim from Centerville GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 141 of 207 people found this instruction helpful
First I unplugged the microwave. :) Then, I removed the 6 screws found underneath the microwave, which allowed the bottom piece to hang down so I could see the turntable motor. I took the two screws out holding the motor in place and pulled the electric connectors off the motor terminals. Then I got the new part from PartSelect.com, replaced the electrical c... read more

Grinding sound when tray turned

  • Customer: Charles from Wall NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 80 of 84 people found this instruction helpful
Unscrewed bottom plate of microwave and two screws that secured motor. Disconnect wires. Reversed process when installing new motor. Couldn't have been easier. read more