Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS11743855
The element has male terminals. This bake element is found on the bottom of the oven.
This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.
This part fixes the following symptoms:
first I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires then I took new element and plug the wires in it pushed the element back in place and replaced the two screws
Help other customers find the most helpful instructions.
Were these instructions helpful?
My father and I disconnected the electricity, took the old heating element out. This caused the most trouble as the old connections were impossible to loosen. But once we did, it was easy to get the new ones hooked on and the whole thing back together in less than an hour!
Removed the bake element, checked with voltmeter for resistance which showed open circuit, ordered new element (which arrived in five days), installed. All of this can be done without moving the range, using access through oven door only. Connections to element are slip fits, removed and reinstalled with fingers.
Turned off the circuit breaker for the oven. Took the existing element out (really easy...a couple of screws is all) tested it with my volt meter and saw that it was bad. If you don't have a volt meter a local appliance repair shop may test it for you. Put the element back in so I could flip the breaker and use the stove top while waiting for the new element. New element came within three days. Flipped the breaker again, removed broken element and replaced it with new one. Flipped the breaker on and oven heated right up when preheated to 450 degrees :)
Turn off the power, unscrew the two screws holding the element. Without any tool, pull the wires off the connectors. and remove the bad element.Connect the new element. push into place, and screw it in.Maximum 15 minutes, and didn't get my hands dirty.
I turned off the breaker for the oven. Then I unscrewed the 2 screws holding the element in and pulled the element out. I unhooked the wires from the element and put the new element in. Reconected the wires, pushe it back into place and replaced the 2 screws. Turned the breaker back on and it works GREAT! Way easy!!! ...even for a girl!
Removed two phillips head screws, pulled the element out until the prongs were exposed, pulled off the wire connectors and removed the bad element. After plugging the wires onto the new element, I pushed it back in and replaced the two screws. Easy job! Your web site is wonderful!
First turned the breaker off. Then I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. Reconnected the wires the new element, slid back in nd reiserted the two screws and tightened it all up. Flipped the breaker back and back in business.
see example. that's just how it went. easy. not really worth reporting.
First I disconnected the power at the breaker box. Then I removed the two screws that hold the element in place. I then pulled the old element out about 3 inches and disconnected the two wires. Then connected the two wires to the new element, pushed it back into place, then fastened in place with the two holding screws. Reconnected the power and tested and all worked fine.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.