Models > SVD48600W Maytag

SVD48600W Jenn-Air Range - Overview

Get Parts and Repair Help for SVD48600W

If you know the range repair part you need, you can browse the list of all parts on the SVD48600W, or you can search by name or part description. You can also find your part by where it is located on the SVD48600W by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for SVD48600W parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.58

Light Bulb - 40W

Sold individually.

$30.50

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$12.78

Grease Filter

The filter is made of metal and is intended for use with ranges and cooktops. As per the manufacturer, if this filter is 1/2" less wide than the original, it will still function th...

$2.70

Screw

This screw is sold individually.

$5.00

Screw

This screw is sold individually.

$5.20

Single Door Strike

Sold Individually.

$18.07

2 Piece Broiler Pan

The top of this part is now black.

$43.04

Bake Element - 240V

The element has male terminals. This bake element is found on the bottom of the oven.

$14.48

Natural Gas to Liquid Propane Conversion Kit

To convert back to Natural Gas - you must save old orifices. If you no longer have the old orifices, the burner tubes must be ordered that contain the natural gas orifices.

$40.88

Oven Rack

Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replace Grease Filter

  • Customer: Gene from Washington C.H., OH
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 492 of 497 people found this instruction helpful
Just a couple of minutes to left off the cover grid, left out the old filter and drop in the new one. read more

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford, MA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 101 of 117 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more

Lost all clock and timer display

  • Customer: John from Kuna, ID
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Socket set
  • 67 of 73 people found this instruction helpful
Removed the 4 phillip head screws that hold the trim plate on the bottom of the display panel (and you probably could skip this step).
Next, I removed the knobs from the front of the display panel.
Then I removed the 4 phillip head screws that were located (1 each) behind the knobs.
Finally, I removed the 4 hex head screws from the bottom of t... read more