CSM25MRCEWW Hotpoint Refrigerator - Instructions

Removed ice select control unite from freezer by removing 3 nut screws holding unite in place. Disconnect 2 electrial plug ins.Remove unite from freezer and place on table for easy work space. Remove 4 nut screws holding Solenoid & Arm. Replace with new Solenoid & Arm. Reinstall back in freezer and now we have cube ice again.

Shut off water & elect to refg. moved refg out from wall. Removed back cover. disconnected water & electric connections. Removed old valve and installed new one . Plastic tube fit in same place elect pins (4) snapped in place. Used teflon tape when connecting copper plumbing to stop leaks. Also cut old tubing & replaced copper 1/4" compression ring. Note I ordered part before noon on thursday, part arrived fri AM 9:00 FedEx.reg service. cleaned up mess picked up tools. Refg worked like new. saved money on service call. Thanks

Unplug the refrigerator. Remove the bottom panel the locate the valve on the left side of the refrigerator. Remove the valve. Unplug the two electrical connecters, then remove the two water lines. (At this point there will be a little water escape). Then replace the lines in the new valve, replace the electrical plugs and reassemble the bottom panel.

I simple followed the video shown at part select web site. A piece of cake. accurate info. repair complete in 45 minutes. thank you part select

followed the previous posts, loosened four screws on the front panel, attached panel to new auger and ice bucket, and was good to go. Excellent advice!

Removed drawer cover, removed both drawers, unscrewed broken part, installed the new one, put drawers and cover back.

Repair was easy. All working now.

watched a 2 minute video on installing the connector. Then using the utlity blade cut out a 1/3" section of the tubing and installed the connector. DONE! Leak fixed

I followed the video instructions. They were clear and consise. I removed the trim ring and controls. Them removed the housing and flapper. I did notice a small burr in the plastic chute and foam insulation. I trimmed this off with a utility in hopes this burr caused the flapper to warp. This is the 2nd time the flapper has been replaced in 1.5 yrs. The repair was really easy thanks to the video.

removed 2 screws from broken slide, then I positioned the new slide in place and using original screws secured slide to wall of frig.

remove 3 bucket screws. 1 bracket screw slide bucket back insert drive reverseb steps

I ordered the part and it was replaced. I always worry that I will get the wrong part or it will not fit. The on-line help with the model number gave me the right part, and this was an easy repair. Gusessing that I saved over $100 from needing to call a repair service!

I removed all the items off the shelves of the door. I then removed the top assembly,Then lifted the door off the the bottom hinge and laid it on a flat surface. I then removed and replaced the cam connector on the bottom of the door. I then removed and replaced the cam from the lower right side of the refrigerator. I put the door on the cam without assistance , then reassembled the top assembly. The refrigerator door operated immediately just like it did when it was new over 20 years ago.

It was exactly as shown in your instruction video

Remove items from Freezer, remove panel and defrost condensor coils (most time consuming part of the job). Defrost Heater is held in with two screws and two electrical connectors (remove by hand or with pliers). It's worth replacing the Defrost theromostat and Defrost heater at the same time. Only cost $60 for the two parts and will ensure you have the fix. Use the "outdoor" wire nuts when splicing in the Defrost thermostat, that will ensure you don't have any issues with moisture at the splice. When defrosting the condensor coils, soak up water as the catch tray won't hold the volume of water that will melt off the coils.