Display was too dim to read

ApplianceJenn-Air Range

Modelsvd48600w

Level of DifficultyEasy

Time to do repair15 - 30 mins

Age of ApplianceMore than 10 years

Tools Screw drivers
Socket set

Brad From Bentonville, AR

Oct 31, 2009

0 out of 1 people found this instruction helpful

Open oven door to see the underside of the control panel. There are 4 screws and 4 small bolts to remove. Remove the screws, which frees up the front trim (remove and set aside), then the 4 bolts. Next, remove the burner control knobs. Behind each knob there are 2 small screws; remove these as well. You can now rotate the control panel away from the oven, pulling out from the bottom first. Disconnect the two cabling harnesses and the control panel is then free from the oven.
There is a connector that goes to the keypad. To disconnect this, lift up on both sides of the black connector until it "snaps" up. Then the flat part of the connection lifts up and out of the black part. Next, remove the 2 bolts that hold the display board. To re-assemble, reverse the process: bolt the new display in place; insert the flat connector and press down on the black part until it clicks. re-connect wire harnesses. Slide the control panel back in place, starting with the top to slide it under the lip of the top of the oven. Re-attach knob screws. re-attach bolts on the under-side, then finally re-attach the trim with the 4 screws.

Help other customers find the most helpful instructions.

Were these instructions helpful?

Diagrams and Parts List for this repair

Part PhotoPart DescriptionPriceAvailability

Electronic Clock Control Board

Part Number: PS2077361

$319.84
Recycling Rebate Available
In Stock