374465-1-S-Whirlpool-4450934           -High Limit Thermostat
374465-1-S-Whirlpool-4450934           -High Limit Thermostat 374465-2-S-Whirlpool-4450934           -High Limit Thermostat

High Limit Thermostat

PartSelect Number PS374465

This part will trip the controls if your appliance gets too hot or if it isn't working properly. It is a safety feature.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

  • Compare At

    $64.24
  • You Save

    $10.71
  • Your Price

    $53.53
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 1.9 / 5.0, 2 reviews What's this?
1-2 of 2
 

31 of 40 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:30 - 60 mins

ToolsScrew drivers

CustomerChristy from Paso Robles CA

After using the "self-clean" option, the panel blew out and the door remained locked. We knew we burnt fuses but didn't know which ones. We had a technician come out and tell us which ones. ($70.00) he quoted us a price of $495.00 for parts and labor. We did the repair ourselves and cost us $157

The hardest part was getting the oven out. The double oven is pretty heavy.

The screws were on the sides under a removable strip. Have a table about the same height as the base of the oven. It was easy to slide it straight over to the table.

The schematics are on top of the oven. Although you probably won't need them for the parts we replaced. When you have the oven out and the back panel removed, it is easy to identify the exact parts you are replacing. The part numbers were the same on the fuses. The thermostat was a simple pull apart. Then undo the 2 screws inside the oven. The heat sensor required some figuring. There is a pin that holds it in place in a plastic casing. We used a small flat head screw driver to push the pin flat to loosen it from the casing. This part was behind the digital panel and the only one that didn't require the oven coming out.

We would easily do this project again and glad we did. We saved $340.00 by doing it ourselves. I am glad I found PartSelect.com

Make sure you turn off the breaker to the appliance first. You don't want any electrical surprises. The hospital bill would be more expensive than the repairman !!

Help other customers find the most helpful instructions.

Were these instructions helpful?

5 of 6 people found this instruction helpful

Parts Used

  • High Limit Thermostat

Level of DifficultyDifficult

Time to do repair:More than 2 hours

ToolsScrew drivers

CustomerGary from Kansas City MO

After running the cleaning cycle the oven and broiler will not heat up.

After some major troubleshooting and "some" help from support folks at fixya.com I was able to pin the problem down to a blown thermistor. The repair was very simple - pull the back plate off and remove the two screws holding the thermistor in place. Replace thermistor and test both heating elements. I assume during the cleaning cycle the thermistor was over heated. Makes one wonder if it was a faulty thermistor or will it happen again on the next cleaning cycle.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2