Models > GR556LRKP1

GR556LRKP1 Whirlpool Range - Overview

Get Parts and Repair Help for GR556LRKP1

If you know the range repair part you need, you can browse the list of all parts on the GR556LRKP1, or you can search by name or part description. You can also find your part by where it is located on the GR556LRKP1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for GR556LRKP1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$5.25

Touch-Up Paint - White

$83.79

Dual Element with Limiter - 2400W

With this element, you can adjust the size of the burner you want to use to match your pots/pans.

$2.70

Screw

$18.07

2 Piece Broiler Pan

$4.46

Light Gasket

$2.70

Screw

This screw is sold individually.

$23.87

Light Lens

$54.04

Door Hinge - Left or Right Side

$5.69

Touch-Up Paint - 1/2oz. - Biscuit

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Radiant element, 2400 watt, under Ceran glass cok top needed replacement.

  • Customer: GEORGE from NEWNAN GA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 49 of 106 people found this instruction helpful
turned off power
removed ceran top from cabinet
removed element
installed new element
replaced top
powered up and was done read more

Socket Light had a bad thread

  • Customer: Edmund from Emporium PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 17 of 21 people found this instruction helpful
Socket Lite come with clips attached to the outside
of the housing. After you unhook the 3 lead wires
that are attached to the unit. All you have to do is push in on the clips and release the unit. Then you
snap in the new unit. Attach the 3 wire leads, put a
oven bulb in the socket end, and the install the light cover read more

Stovetop element burned out

  • Customer: Lonnie from Ashton ID
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 14 of 16 people found this instruction helpful
First of all, I shut off the electricity to the stove.

I had to remove the two screws holding the stovetop in place. I then lifted it up and braced it to keep it from falling, removed the bad element, carefully marking the 4 wires that were connected to the element. I then disconnected the wires, and removed the two brackets holding the elemen... read more