Models > GR556LRKB1

GR556LRKB1 Whirlpool Range - Overview

Get Parts and Repair Help for GR556LRKB1

If you know the range repair part you need, you can browse the list of all parts on the GR556LRKB1, or you can search by name or part description. You can also find your part by where it is located on the GR556LRKB1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for GR556LRKB1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$83.79

Dual Element with Limiter - 2500/1200W

With this element, you can adjust the size of the burner you want to use to match your pots/pans.

$2.70

Screw

$18.07

2 Piece Broiler Pan

$4.65

Touch-Up Paint - White

$4.46

Light Gasket

$2.70

Screw

This screw is sold individually.

$23.87

Light Lens

$3.96

Rear Leveling Leg

Sold individually.

$61.68

Surface Ribbon Element with Limiter - Small

This is a 1500 watt surface element.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Radiant element, 2400 watt, under Ceran glass cok top needed replacement.

  • Customer: GEORGE from NEWNAN GA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 54 of 114 people found this instruction helpful
turned off power
removed ceran top from cabinet
removed element
installed new element
replaced top
powered up and was done read more

No heat on burner

  • Customer: paul from trumbull CT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Socket set
  • 18 of 24 people found this instruction helpful
Turned off electricity! Pulled stove out -lifted up glass top(carefully) simply removed burned out coil and replaced it with new one. read more

Socket Light had a bad thread

  • Customer: Edmund from Emporium PA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 17 of 21 people found this instruction helpful
Socket Lite come with clips attached to the outside
of the housing. After you unhook the 3 lead wires
that are attached to the unit. All you have to do is push in on the clips and release the unit. Then you
snap in the new unit. Attach the 3 wire leads, put a
oven bulb in the socket end, and the install the light cover read more