298716-1-S-GE-WR2X7905          -Ice Bucket Seal
298716-1-S-GE-WR2X7905          -Ice Bucket Seal 298716-2-S-GE-WR2X7905          -Ice Bucket Seal 298716-3-S-GE-WR2X7905          -Ice Bucket Seal

Ice Bucket Seal

PartSelect Number PS298716

This part works with the following brands: GE, Hotpoint & Kenmore.

  • Compare At

    $5.16
  • You Save

    $.86
  • Your Price

    $4.30
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.6 / 5.0, 4 reviews What's this?
1-4 of 4
 

18 of 31 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:30 - 60 mins

ToolsScrew drivers, Wrench set

CustomerAllan from Pleasanton CA

Meatal parts were rusted

the part is fairly easy to take apart, however pay close attention to how things fit and go together. It took me sometime to figure the reassembly out due to my lack of close attention to taking it apart. other than that it is simple.

Help other customers find the most helpful instructions.

Were these instructions helpful?

8 of 12 people found this instruction helpful

Parts Used

Level of DifficultyDifficult

Time to do repair:More than 2 hours

ToolsPliers, Screw drivers

CustomerPaul from Ashton MD

Bucket drive shaft disengaged from motor drive

This is a 25 year old unit. The ice bucket had warped over time causing the face plate to move forward of its ideal position pulling the entire assembly out of the drive. Removed dispensing unit face assembly. Removed drive shaft assembly. Replaced all washers. Reversed old broken drive cup. Married old drive cup to new drive cup...lining up drive slots. Drilled 6 ea. 3mm holes evenly spaced around circumference into the face of the old drive cup. Fastened drive cups together in vice and with C clamp...then using phillips head screws installed 3 ea. from opposing entry points on each side of this homemade shaft extender. This "mechanism" increased the effective length of the dispensing shaft assembly allowing for a proper fit of the drive shaft to the motor drive connection. Unit now works perfectly. Total cost @ $40.00 and two hours work which would have taken less than one hour if I had remembered to install the ice bucket seal the first time. New ice bucket would have cost @ $185.00. Home warranty does not cover ice makers or any of the associated parts. DIY...it isn't that difficult.

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 5 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsScrew drivers

Customerharvey from shawnee KS

Original ice bucket had a broken auger guide

the parts arrived the next day!!! Awesome.

Detached the original bucket from the dispenser face plate by removing all screws. Must remember where all the screws go. Attached new bucket to original dispenser face plate. Very easy.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 2 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:30 - 60 mins

ToolsScrew drivers

CustomerJorge from Aventura FL

Rusty and broken plastic parts

It was just a matter of replacing the broken parts, and reassembling the ice machine. Nothing too difficult.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-4 of 4