Quick Question!

Have you ever purchased from PartSelect.com before?

297809-1-S-GE-WR2X4141          -Roll Pin
297809-1-S-GE-WR2X4141          -Roll Pin http://www.partselect.com/Schematics/GE/00120714i05.gif

Roll Pin

PartSelect Number PS297809

This part works with the following brands: GE, Hotpoint & Kenmore.

Compare At

$6.71

You Save

$1.12

Your Price

$5.59
Get this part fast. Average delivery time via regular ground: 1.8 days.

Related Parts Additional or alternate parts to consider.

Part PhotoPart DescriptionPriceAvailability

Dispenser Blade Rest

Part Number 297808

$6.70
In Stock

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 1.9 / 5.0, 2 reviews What's this?
1-2 of 2
 

10 of 16 people found this instruction helpful

Parts Used:
Level of Difficulty: Difficult
Time to do repair: More than 2 hours
Tools: Pliers, Screw drivers
Customer: Paul from Ashton, MD

Bucket drive shaft disengaged from motor drive

This is a 25 year old unit. The ice bucket had warped over time causing the face plate to move forward of its ideal position pulling the entire assembly out of the drive. Removed dispensing unit face assembly. Removed drive shaft assembly. Replaced all washers. Reversed old broken drive cup. Married old drive cup to new drive cup...lining up drive slots. Drilled 6 ea. 3mm holes evenly spaced around circumference into the face of the old drive cup. Fastened drive cups together in vice and with C clamp...then using phillips head screws installed 3 ea. from opposing entry points on each side of this homemade shaft extender. This "mechanism" increased the effective length of the dispensing shaft assembly allowing for a proper fit of the drive shaft to the motor drive connection. Unit now works perfectly. Total cost @ $40.00 and two hours work which would have taken less than one hour if I had remembered to install the ice bucket seal the first time. New ice bucket would have cost @ $185.00. Home warranty does not cover ice makers or any of the associated parts. DIY...it isn't that difficult.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

5 of 11 people found this instruction helpful

Parts Used:
Level of Difficulty: A Bit Difficult
Time to do repair: 15 - 30 mins
Tools: Screw drivers
Customer: Kelly from Canandaigua, NY

Ice maker would not crush ice.

Removed tray from ref. Removed from cover from tray useing a screwdriver. Removed housing, took old parts out. Make sure you take the parts out in order and put new parts back in same order as old parts.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2