ZISB48DCA General Electric Refrigerator - Instructions

Went to GE website and researched the problem for the model, determined that it was 90% sure it was the Ice maker, I ordered it and it arrived the next day, installed it and it began working immediately,

just as written out with part

Removed ice select control unite from freezer by removing 3 nut screws holding unite in place. Disconnect 2 electrial plug ins.Remove unite from freezer and place on table for easy work space. Remove 4 nut screws holding Solenoid & Arm. Replace with new Solenoid & Arm. Reinstall back in freezer and now we have cube ice again.

followed the previous posts, loosened four screws on the front panel, attached panel to new auger and ice bucket, and was good to go. Excellent advice!

Repair was easy. All working now.

I followed the video instructions. They were clear and consise. I removed the trim ring and controls. Them removed the housing and flapper. I did notice a small burr in the plastic chute and foam insulation. I trimmed this off with a utility in hopes this burr caused the flapper to warp. This is the 2nd time the flapper has been replaced in 1.5 yrs. The repair was really easy thanks to the video.

To find the problem, I operated the water dispenser in the door. Leak appeared at water inlet valve on rear of refrig. Went to "PartSelect", found the exact part and ordered it. It was simple to replace: 1) disconnect refrig power and remove the rear access panel. 2)remove the valve assembly bracket from refrig (1 screw) and pull out 3) unscrew the defective valve from bracket 4) disconnect 2 electric plugs from valve 5) turn off water at supply and unscrew the inlet water fitting to detach the inlet tube 6) cut the output water tube that comes out of the defective valve-- the old valve can now be discarded. Then, just push the cut end of the output water tube into the new valve until you feel it hit the stop, reattach the 2 electric plugs and the inlet water tube and tighten the fitting. Push assembly back into frig and reattach holding screw. Finally turn on water and check operation for no leaks and then reattach access panel.

remove 3 bucket screws. 1 bracket screw slide bucket back insert drive reverseb steps

It was exactly as shown in your instruction video

Carefuly

Pulled the refrigator form the wall, removed lower back panel and found the inlet water supply valve was leaking from the housing.Got the refrig model # and went to GE parts on line. Parts select popped up entered model # and blowen up parts brake down should up. Picked the part I needed called customer service and three days later part arrived. In about 10 minutes the refrigator was back working.

Removed rear panel, removed bolt holding valve assembly, pulled valve assembley toward rear to get access to screws to remove valve from assembly, removed electrical plugs and removed valveby it self. Had a little trouble removing line from valve. NO INSTRUCTIONS ON HOW TO REMOVE PLASTIC LINE FROM VALVE, Twisted on line and pulled and line finaly came out. Pushed line into new valve, mounted valve to assembly and connected electrical connectors on. pushed assembly back in and installed holding bolt, added cover to back and all's well.

Ice bucket and auger came fully assembled. Just had to attach the face plate from the broken ice bucket assembly and slide it into the freezer. There were only four Phillips screws involved.

Went well. Changed the Ice Maker and then the Water Valve. All good and it is making ice.

Watched à video provided at your website. Removed te cover then removed 4 screws holding the control panel' snapped out the old flap and inserted the new one.