PSS26SGRBSS General Electric Refrigerator - Instructions

I went to internet and reserched this site and put the model number in serch. Great site for instructions. I looked for the double valve and a union connector. Did not know what they looked like so I searched the detailed parts of the back of the ref. Looked at the video on how to install parts very easy. I ordered the parts. They came really fast within two days in the mail. The video told you what tools you would need to do the job. Pulled the ref out, set on the floor, undid the 6 or 7 screws from back panel and followed the instructions from video. The part itself had only 1 screw to remove. I'm 64 female and it was really easy and I now have water.

Followed directions and it was quite easy.

Used a 2" putty knife to lift off the old switch. Disconnected the broken switch and replaced it with the new one. Took about 1 minute.

After reading some of the reviews. I bought and replaced the main circuit board. The parts came quickly and the job took very little time. Good time to remove all the panels on the back and clean the dust off everything. Refrig. is running great now! Easy fix! Thanks to all the help.

I watched the video on the website and the repair was done quickly and easily. Turned out I didn't need any parts because the spring that closes the door had somehow gotten out of place. Returned spring to proper position and the door now closes. Due to the door staying open the ice in the dispenser was melting and refreezing, thereby stopping the flow of ice. Without the video I wouldn't have attempted this repair.

No big deal. Tiny space to work in. Patience. Patience

We received the part just a few days after ordering, unscrewed the old filter by hand, and installed the new filter the same way.

Little difficult getting the switch out, had to pry wth some force. New installation was real easy.

1. Unplug refrigerator 2. Remove cover from bottom rear of refrigerator 3. Remove screw from damaged part 4. Transfer over water lines to new part and reinstall 5. Plug refrigerator and test 6. Replace bottom rear cover 7. Move refrigerator back into position

Placed the new shelf in the slot. Very easy and a clean, snug fit. Thanks for the great customer service and fast shipping!

I followed the directions written by others on this repair. The tip to take pictures of the blade assembly was very benficial. One very important point was left out. The latex nut on the end of the shaft is reverse threaded. Turn clockwise to loosen. My C-Clip, also known in my industry as an E-Clip, was tricky to remove. It required the use of a thin bladed screw driver and needle nose pliers. Use care in not deforming the latex nut. Additionally, remove the metal bar from the shaft in order to slide it into the slots on the Helix. My wife had to help me with the reassembly. The extra set of hands were needed to keep the alignment as the smaller unit was positioned into the outer case. Good Luck!

Replace main board.

Really easy- turned off ice maker, powered down appliance briefly. Removed ice maker by removing 3 screws with 1/4 nut driver. Unplugged ice maker from power supply. Removed and replaced solenoid arm assembly. Reversed steps and whammy - ice cubes dropped.

I looked at the video that came with the part and followed what i saw. My wife and i was about to go out and spend between $1500 and $2500 on a new refrigerator due to continuous defrosting. It had been happening for about a year. I followed the instructions from the video and the defrosting has stopped. Thanks so much for the video and the part! We do not need a new refrigerator after all.

Took old part out , put new part in. Was so easy thought we did it wrong. Ice maker working great, have lots of ice now. Thank you. Colleen