MDE9206AYW Maytag Dryer - Instructions

Watched the video on this website, did same. I would have broken more parts than I repaired, were it not for the easy to follow step-by-step instructions on the video.

This was real easy just slid the latch in front panel and attached to latch assembly to the door. The repair was about 45 seconds.

My first thought was to replace the drive belt. I followed the excellent how-to video and, once inside, discovered that the belt was fine and that the right-hand drum roller was worn out and squeaking when I rotated it by hand. I should have listened to the other customers who said I should replace the drum support rollers at the same time as the belt. I did a thorough lint cleaning, put the dryer back together and ordered one roller replacement kit. It arrived in a just few days. I was able to lift the drum off the rollers and replace the bad roller without having to remove the drive belt. It took under 1/2 hour. There was only one omission in the video: I had to remove two metal tabs that hold down the dryer lid. Just one screw on each side. Recommendation: Purchase a pair of snap ring pliers. They make removing and reinstalling the the snap retainer ring a breeze in a tight working space.

Fine. Make sure you watch the video provide by PartSelect.

im a car mecanic it was easy

went very well. Only took 10 min.

Watch the video

Very easy followed video of repair for part and it took 5 min. My kind of repair!Cost effective as well $4.95 + shipping. My wife was talking new dryer at $900. Yikes!!!

After fearing that I would have to call a repairman or buy a new dryer, I took the model number off my dryer and went on line for replacement parts. I found your site and worked my way through the parts that I would need. The video showing how things are done was very helpful, eventhough this was a simple repair it was nice to see how to make the repair and helped confirm that I understood what I was doing. Thank you.

Put together the parts in seconds and reattached.

very easy to install. thanks

Removed 2 front panel screws and pulled out bottom to disengage top clips. Unplugged two light wires. Set front panel aside. Remove 4 screws that support the front drum support. Remove panel in back to reveal motor and belt. NOTE HOW BELT IT THREADED AROUND IDLER AND PULLEY. Remove belt from pulley. Remove front drum support and set aside Pulled out drum and set aside. NOTE ORIENTATION OF RIBS ON BELT. Remove snap ring on roller shaft inside of machine. Pull off roller and two washers. Replace 1 washer, 1 roller ,1 washer in that order. Replace snap ring. Replace glides on drum support while apart. Drill out rivets and remove glide assembly. Replace with new parts and put rivet in hole to align. Rivet into place. Make sure glide assembly is seated by forming it to front drum assembly. Align second hole and rivet together. Reassemble in reverse.

put the new filter in Was a Breeze Thanks I got the filter in a feww days Thank again for your fast service

Just replaced the filter in the front door of the dryer. Part Select did an awesome job of getting the part to me in record time. Excellent experience.

The whole job was fairly easy. The on line video helped prepare me for what I would need to do. My best advice is buy snap ring pliers. Without the pliers I tried for over a hour to remove the snap rings for the drum rollers. With the pliers it took 10 minutes to remove and install the new parts. Money well spent. I replaced the drive belt only because it was a relatively cheap part and I knew I was going to have the whole dryer disassembled anyway, so why not.