HDA105Y-70WH Hotpoint Dishwasher - Instructions

Instructions for repairs. Remove old rack from dishwasher. Stop, have a beer. Open packing box. Remove new dishwasher rack from box. Rest. Have another beer. Slidey old thingamajig rack ouy from dithwather. Shove into packing box. Figure out where you put the new rack. Pick up new rack, put new rack on countertop. Hav anoder beer. Put nw wreck in dithwather. Take bx & bee botluls to trash. Take nap. :>) S.

Installed new ones as per instruction

I ordered the corner baffles and installed them in the corners in just minutes. Repair company quoted me about $100 if they had the parts on the truck. If they had to come back it would be another service call. Did the repairs my self for $24 with shipping charges. Happy Customer

Simply replaced both cables to allow door to open and operate as intended, without dropping unrestrained, which could possibly cause more serious damage to door and/or washer.

follow your video instruction. very simple.

I took the slide ends off the slides. Removed the top rack, removed the old worn out rollers. Installed the new rollers. I turned the slides over as the top of the slides weren't as worn as the bottoms. I replaced the slide end caps on the inside of the slides, put the rack back on the slides. Replaced the slide ends on the outside of the slides.

Pulled out the old and rolled in the replacement. The easiest part of the repair was ordering from the PartSelect website and receiving it via FedEx Ground the next day. Thank you PartSelect. Even my husband could have been successful with this.

just ordered the parts and sat them in place...I thought at first I would need a new dish washer...wow too easy finding the reason and the parts..thank you so much!! saved hundreds of dollars,ps I am a woman,not mechanically inclined

I took the cover off the bottom of the diswasher. Took each eyelet cable with circular opening and connected to pin on each bottom side of the door. I replaced both eyelet cables as was recommended. Ran cable around the outside of the pulleys and connected each eyelet cable to the two springs. My only question was: "did the longer spring go on the bottom or the top?" I ended up putting the longer spring on the top holes of the eyelet cables. Tested the operation of the door and it worked normally. Screwed the cover plate back on the bottom of the dishwasher and problem fixed! Quite easy.....

Found the parts on line, placed the order and received the parts within 3 days. Very easy to install the parts. Very happy with my experience with PartSelect. Thank you.

It was very easy for me; my husband did it. He had no difficultly at all. The step by step eamail was great.

i found the part and order it on the site sooooo easy. it came in no time , i took the old one out in 10 seconds and place the other one (NEW) in place in less than a minute.it works fine and thanks to u alllllll

clicked in without effort. The new parts are better designed to be replaced. Need to better describe packaging to show 4 rollers per pack. Also need to caution buyers that rack end caps should be ordered at the same time. The older end caps easily break.

ordered new rack which was delivered in just a few days and out of the box in to the place were the old rack had been. old rack into the shipping box and into the garbage can. Sweet!

removed old baffle and cleaned area and installed new one